Tool Wear in Cutting Glass-Fiber-Reinforced-Plastics : The Relation between Cutting Temperature and Tool Wear
نویسندگان
چکیده
منابع مشابه
Cutting tool wear estimation for turning
The experimental investigation on cutting tool wear and a model for tool wear estimation is reported in this paper. The changes in the values of cutting forces, vibrations and acoustic emissions with cutting tool wear are recoded and analyzed. On the basis of experimental results a model is developed for tool wear estimation in turning operations using Adaptive Neuro fuzzy Inference system (ANF...
متن کاملEvaluation of Flank Wear of Iron-rich Binder Carbide Cutting Tool in Turning of Titanium Alloy
Despite the fact that Titanium material has been considered as difficult to cut material, its usage has been increasing day by day in all engineering sectors; wherever criticality is encountered. Many studies are going on in view of increasing tool life at high cutting speed to improve productivity. In this study, attempt has been made to see the effect of iron as a partial substitution along ...
متن کاملCharacterizations of cutting tool flank wear-land contact
Metal deposition at the tool flank wear-land during machining is a common phenomenon, especially in machining aluminum alloys and annealed teels. The cause of metal deposit has not been studied and the characteristics of the wear-land and deposit contact are not completely known. In his study, a turning test was conducted using tungsten carbide (WC) tools with pre-generated wear-land to machine...
متن کاملTool wear monitoring and selection of optimum cutting conditions with progressive tool wear effect and input uncertainties
One of the big challenges in machining is replacing the cutting tool at the right time. Carrying on the process with a dull tool may degrade the product quality. However, it may be unnecessary to change the cutting tool if it is still capable of continuing the cutting operation. Both of these cases could increase the production cost. Therefore, an effective tool conditionmonitoring systemmay re...
متن کاملInvestigating Flank Wear and Cutting Force on Hard Steels by CBN Cutting Tool by Turning
In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1980
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.46.990