Thermodynamic Studies on Lead-Bismuth Alloys
نویسندگان
چکیده
منابع مشابه
Equilibrium, Kinetic, and Thermodynamic Studies of Lead (ii) Biosorption on Sesame Leaf
Sesame leaf, an agricultural solid waste, was used as low cost adsorbent for removal of Pb(II) from aqueous solution in batch mode. The biosorbent was characterized by thermo-gravimetric analysis and Fourier transform infrared spectroscopy. The influences of phase contact time, solution pH, adsorbent dosage, and initial concentrations were investigated to optimize the conditions for maximum ads...
متن کاملThermodynamic measurements of Fe-Rh alloys.
FeRh undergoes an unusual antiferromagnetic-to-ferromagnetic (AFM-FM) transition just above room temperature (T(AFM>FM)) that can be tuned or even completely suppressed with small changes in composition. The underlying temperature-dependent entropy difference between the competing AFM and FM states that drives this transition is measured by specific heat as a function of temperature from 2 to 3...
متن کاملBismuth Telluride and Its Alloys as Materials for Thermoelectric Generation
Bismuth telluride and its alloys are widely used as materials for thermoelectric refrigeration. They are also the best materials for use in thermoelectric generators when the temperature of the heat source is moderate. The dimensionless figure of merit, ZT, usually rises with temperature, as long as there is only one type of charge carrier. Eventually, though, minority carrier conduction become...
متن کاملHandbook on Lead-bismuth Eutectic Alloy and Lead Properties, Materials Compatibility, Thermal-hydraulics and Technologies
3.2 Enthalpies, entropies (solid and liquid state) – free energy and entropy of mixing The heats of formation of six solid Pb-Bi alloys have been measured at 400 K in a liquid lead solution calorimeter by P. Roy, et al. They found that these alloys obey Kopp’s law of additivity and the heats of formation are therefore temperature independent. The lead and bismuth used in these experiments were ...
متن کاملGenotoxicity studies of heavy metals: lead, bismuth, indium, silver and antimony.
OBJECTIVES Many kinds of heavy metals are used in industry; thus, it is important for us to clarify their toxicity. For example, lead, which is a component of solder, is notorious for its neurotoxicity, and substitute materials have been sought for many years. Therefore, we examined the genotoxicity of lead and also those of metallic bismuth, indium, silver and antimony which are possible subst...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1960
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.24.10_668