Thermodynamic calculations in alloys Ti-Al, Ti-Fe, Al-Fe and Ti-Al-Fe
نویسندگان
چکیده
منابع مشابه
Assessment of the Al–Fe–Ti system
The Al–Fe–Ti system has been assessed and the limiting binary systems are shortly reviewed. Based on a thorough review of the literature, isotherms at 800, 900, and 1000 °C have been re-evaluated and a provisional isotherm at 1200 °C is presented for the first time. The effect of alloying the binary phases with the third component is reviewed with regard to the ternary homogeneity ranges, cryst...
متن کاملCALCULATION OF THERMODYNAMIC PROPERTIES OF Al-Fe, Al-Ni AND Ni-Fe ALLOYS USING FACTSAGE
Thermodynamic predicting analysis of three binary systems Al-Fe, Al-Ni and Ni-Fe are shown in this paper. Thermodynamic analysis involved calculation of activities, coefficient of activities, partial and integral values for enthalpies and Gibbs energies of mixing and excess energies at three different temperatures: 1873K, 1900K and 1973K, as well as calculated phase diagrams, for the investigat...
متن کاملDIFFICULTIES IN GRAIN REFINING ALUMINUM LITHIUM ALLOYS USING COMMERCIAL Al-Ti AND Al-Ti-Bor MASTER ALLOYS
High strength aluminum alloys, especially those containing zirconium, are historically difficult to grain refine. Early efforts by Alcoa indicated that the addition of lithium to these alloys increases difficulty with grain refinement. Although grain refining of alloys 2090 and 2091 was possible, consistent results were not obtained. Statistically-designed experiments were used to quickly ident...
متن کاملElectrical conductivity of dense Al, Ti, Fe, Ni, Cu, Mo, Ta, and W plasmas.
We report measurements of electrical conductivity of eight metals in the plasma state at densities ranging from 0.002 to 0.5 times solid density, and with internal energy from 2 to 30 kJ/gm. Data are presented as functions of internal energy and specific volume. Conductivity is observed to fall as the plasma expands for fixed internal energy, and for all but tantalum and titanium shows a minimu...
متن کاملGradient Distribution of Martensite Phase in Melt-Spun Ribbons of a Fe-Ni-Ti-Al Alloy
Metallographic, X-ray diffraction and magnetometric analysis were used to study the regularities of martensitic transformation in melt-spun ribbons of a Fe - 28 wt. % Ni - 2.1 wt. % Ti - 2 wt. % Al - 0.05 wt. % C alloy. The substantial differences in volume fractions of the martensite phase in local regions of thin melt-spun ribbons of the alloy are related to the size effect of the transformat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Mining and Metallurgy, Section B: Metallurgy
سال: 2008
ISSN: 1450-5339,2217-7175
DOI: 10.2298/jmmb0801049k