Thermo-Elasto-Plastic Stress Analysis in Equilibrium Profile of SMT Solder Joints.
نویسندگان
چکیده
منابع مشابه
Characterization of elasto-plastic behavior of actual SAC solder joints for drop test modeling
Article history: Received 30 December 2010 Received in revised form 27 February 2011 Accepted 2 March 2011 Available online 6 April 2011 0026-2714/$ see front matter 2011 Elsevier Ltd. A doi:10.1016/j.microrel.2011.03.019 ⇑ Corresponding author. Tel.: +1 607 777 3415. E-mail address: [email protected] (S. Park). This paper focuses on the characterization of the elasto-plastic properties of ...
متن کاملNonlinear Analysis of Plastic Ball Grid Array Solder Joints
(2001) Nonlinear analysis of plastic ball grid array solder joints. Notice: Changes introduced as a result of publishing processes such as copy-editing and formatting may not be reflected in this document. For a definitive version of this work, please refer to the published source: ABSTRACT A nonlinear finite element analysis was carried out to investigate the viscoplastic deformation of solder...
متن کاملIntermetallics in Solder Joints
Introduction Intermetallic compounds (IMCs) are generally considered a bad thing in solder joints, though this is not always the case. Excessive IMCs in solder joints are a bad thing since they significantly alter both the composition and the mechanical performance of the solder joint. Interfacial IMC layers can be an indication of the quality of the solder joint and the lack of them would indi...
متن کاملEvaluation of Elasto-Plastic Interfacial Fracture Parameters in Solder-Copper Bimaterial Using Moir6 Interferometry
An experimental investigation dealing with failure characterization of 63/37 soldercopper interfaces is presented. The method of moird interferometry is used for mapping elasto-plastic deformations in bimaterials subjected to predominantly tensile loading. A method for quantifying the fracture parameter--the J-integral--using full-field measurement of crack opening displacements has been develo...
متن کاملElectromigration in Solder Joints and Solder Lines
Au (0.05 μm) 69.4 μm Electromigration may affect the reliability of flip-chip solder joints. Eutectic solder is a two-phase alloy, so its electromigration behavior is different from that in aluminum or copper interconnects. In addition, a flipchip solder joint has a built-in currentcrowding configuration to enhance electromigration failure. To better understand electromigration in SnPb and lead...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1998
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.64.949