منابع مشابه
Fuzzy-Neuro Controler for Smart Fault Detection of a Beam
This paper addresses the fault detection of a cracked cantilever beam using a hybrid artificial intelligence technique. The hybrid technique used here uses a fuzzy-neuro controller. The fuzzy-neuro controller has two parts. The first part is comprised of the fuzzy controller, and the second part is comprised of the neural controller. The input parameters of the fuzzy controller are relative dev...
متن کاملEvolutionnary stair climbing controler for Unmanned Ground Vehicles
This paper presents a way to autonomously climb staircases with vehicles able to move their centre of gravity by changing their geometry. Grounded vehicles are categorised and a new architecture developed in our laboratory is described. After a survey about existing autonomous staircase clearing systems we propose a different approach based on a genetic training which control the adaptation of ...
متن کاملChrome Electroplating Waste BAT
During the past several years, waste produced by the electroplating industry has attracted attention due to the level of pollutants found in the waste stream, the difficulty associated with treatment, and the cost of waste disposal. EPA has enacted regulations to control the discharge from plating facilities and estimates that 140 million lb of metal pollutants will be prevented from being disc...
متن کاملTreatment of Electroplating Wastes
~sing of the environment, the electroplating industry is likely to be one of the industries to be affected by the introduction of the water pollution control legislation in Hong Kong. The effect may be even more pronounced for the operators of small and medium-sized electroplating factories since they are unlikely to have any expertise in pollution control and will therefore require outside tec...
متن کاملNickel electroplating for nanostructure mold fabrication.
We demonstrated a practical process of fabricating nickel molds for nanoimprinting. Dual-side polished glass is chosen as the substrate on which nickel nanostructures are successfully electroplated. Photonic crystal structures with 242 nm diameters and other nanoscale pillars down to 9 nm diameters are achieved over a large area. The electroplating parameters are investigated and optimized. Thi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surface Finishing Society of Japan
سال: 1989
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.40.960