Thermal Stresses in Circular Disc Due to Instantaneous Point Heat Source
نویسندگان
چکیده
منابع مشابه
Mechanical and Thermal Stresses In a Linear Plastic FGM Hollow Cylinder Due to Axisymmetric Loads
In this paper, an analytical solution for computing the linear plastic stresses and critical temperature and pressure in a FGM hollow cylinder under the internal pressure and temperature is developed. It has been assumed that the modulus of elasticity and thermal coefficient of expansion were varying through thickness of the FGM material according to a power law relationship. The Poisson's rati...
متن کاملMechanical and Thermal Stresses in a FGPM Hollow Cylinder Due to Non-Axisymmetric Loads
In this paper, the general solution of steady-state two-dimensional non-axisymmetric mechanical and thermal stresses and mechanical displacements of a hollow thick cylinder made of fluid-saturated functionally graded porous material (FGPM) is presented. The general form of thermal and mechanical boundary conditions is considered on the inside and outside surfaces. A direct method is used to sol...
متن کاملSimulation of Thermal Stresses in a Brake Disc
In this thesis thermal stresses in a brake disc during a braking operation are simulated. The simulations are performed by using a sequential approach where the temperature history generated during a frictional heat analysis is used as an input for the stress analysis. The frictional heat analysis is based on the Eulerian method, which requires significantly lower computational time as compared...
متن کاملSteady Thermal Stresses in a Thin Rotating Disc of Finitesimal Deformation with Mechanical Load
Seth’s transition theory is applied to the problems of thickness variation parameter in a thin rotating disc by finite deformation. Neither the yield criterion nor the associated flow rule is assumed here. The results obtained here are applicable to compressible materials. If the additional condition of incompressibility is imposed, then the expression for stresses corresponds to those arising ...
متن کاملTransient Three-Dimensional Thermal Analysis of a Slab with internal heat generation and heated by a Point Moving Heat Source
In this work, analysis of transient three-dimensional heat transfer in a slab with internal heat generation and heated by a point moving heat source along its axis is carried out using integral transforms methods. The heat input into slab or workpiece by the moving heat source is considered in the model. From the results, it was established that the temperature of the material during the heat t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1966
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.32.1470