The Welding of Dissimilar Joints with Low Temperature Martensitic Transformation Filler Material
نویسندگان
چکیده
منابع مشابه
Laser welding of dissimilar aluminium alloys with filler material
Laser welding of dissimilar aluminium alloys with filler material Luís Filipe Amaro Pinto Instituto Superior Técnico – Technical University of Lisbon – Portugal September 2008 Abstract The aluminium alloys are materials with great potential because of its high strength and low weight. However, the welding of dissimilar aluminium alloys is difficult in autogeneous welding, due to these alloys ar...
متن کاملEvaluation of the Melted Zone Microstructure in the Interface of the Dissimilar Weld between A335 Low Alloy Steel and ER309L Filler Metal by Gas Tungsten Arc Welding
In the present study, the microstructure and mechanical properties of the dissimilar welding between ASTM A335 low alloy steel and ER309L austenitic stainless steel were investigated using the gas tungsten arc welding process. The welding of dissimilar materials between ASTM A335 low alloy steel and ER309L austenitic stainless steel was found to have a significant effect on the microstructure w...
متن کاملElectrical conductance between conductors with dissimilar temperature-dependent material properties
The method of Greenwood and Williamson is extended to give a general solution for the coupled nonlinear problem of steady-state electrical and thermal conduction across an interface between two conductors of dissimilar materials, for both of which the electrical resistivity and thermal conductivity are functions of temperature. The method presented is sufficiently general to cover all combinati...
متن کاملEvolution of Microstructure in Brazed Joints of Austenitic-Martensitic Stainless Steel with Pure Silver Obtained with Ag-27Cu-5Sn Brazing Filler Material
Brazing of an austenitic-martensitic stainless steel (AMSS) with pure silver was carried out at 1053 K, 1073 K, and 1093 K (780 C, 800 C, and 820 C) with Ag-27Cu-5Sn (wt pct) as brazing filler material (BFM). Wettability of the liquid BFM over base AMSS surface was found to be poor. Application of nickel coating to the steel was observed to enhance the wettability and to enable the formation of...
متن کاملEvaluation Of Mechanical Properties Of Dissimilar Metal Tube Welded Joints Using Inert Gas Welding
Evaluation of welding process such as metal inert gas welding and tungsten inert gas arc welding on tensile, bend and hardness properties of austenitic stainless steel SS347H(18Cr 10Ni 1Cb ), T22(21⁄4Cr Mo) and T91(9Cr 1Mo V) grades are studied. Tubes of 54 mm of outer diameter and 4 mm of wall thickness is used as a base material in the following combination SS347H VS T91 and T91 VS T22 is wel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Soldagem & Inspeção
سال: 2018
ISSN: 1980-6973,0104-9224
DOI: 10.1590/0104-9224/si2304.06