Temperature-driven surface morphology evolution of poly(3-hydroxybutyrate) single layer and poly(3-hydroxybutyrate)/poly(vinyl phenol) bilayer on Si wafers
نویسندگان
چکیده
منابع مشابه
Dip coating of silica layer on melt-spun Finemet ribbons: surface morphology and electrical resistivity changes
In this study, melt-spun Finemet ribbons were coated by a thin layer of SiO2 using dip coating method. Amorphous ribbon prepared by melt spinning method and dip coating were done by using a solution of tetraethylen orthosilicate as a SiO2 precursor, ethanol as solvent and distilled water for hydrolysis. Different thicknesses of SiO2 layer, namely 304, 349, 451, 526 and 970 nm were obtained prop...
متن کاملThe Effect of Temperature on the Fracture Surface Morphology and Ductility of La55Al25Ni5Cu10Co5 BMG
In this research, the effect of temperature on the mean size of fracture surface features, as well as the relation between fracture surface morphologies and ductility of a La-based BMG as a relatively brittle alloy, was systematically investigated. After producing the alloy, three-point bending experiments, over a wide range of temperatures, were conducted on the samples; then the fracture surf...
متن کاملSurface Morphology Transformation Under High-Temperature Annealing of Ge Layers Deposited on Si(100)
We study the surface morphology and chemical composition of SiGe layers after their formation under high-temperature annealing at 800-1100 °C of 30-150 nm Ge layers deposited on Si(100) at 400-500 °C. It is found that the annealing leads to the appearance of the SiGe layers of two types, i.e., porous and continuous. The continuous layers have a smoothened surface morphology and a high concentra...
متن کاملEfficiency Enhancement of Si Solar Cells by Using Nanostructured Single and Double Layer Anti-Reflective Coatings
The effect of single and double-layer anti-reflective coatings on efficiency enhancement of silicon solar cells was investigated. The reflectance of different anti-reflection structures were calculated using the transfer matrix method and then to predict the performance of solar cells coated by these structures, the weighted average reflectance curves were used as an input of a PC1D simulation....
متن کاملSurface morphology of semiconducting iron silicides grown on Si( 111)
A surface roughness analysis of P-Fe%, films grown by solid phase epitaxy on Si(ll1) substrates is presented. The composition and stoichiometry of the silicides are determined by X-ray photoemission spectroscopy. Pinholes are detected in thick samples grown by the SPE method. Quantitative measurements of the roughness for different FeSi, thicknesses are based on scanning tunneling microscopy im...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chinese Journal of Polymer Science
سال: 2013
ISSN: 0256-7679,1439-6203
DOI: 10.1007/s10118-013-1240-9