SYNTHESIS AND CONTROL 3-DOF PLANAR PARTLY DECOUPLED PARALLEL MANIPULATOR
نویسندگان
چکیده
منابع مشابه
Position Control of a 3 - DOF 3 - RRR Planar Parallel Manipulator Using Model Predictive Control
This paper presents the position control of a 3-DOF 3-RRR planar parallel manipulator by using the model predictive control. Not only the numerical simulations are demonstrated but also an experimental hardware-in-the-loop system is constructed. The experimental results are used to verify the simulation results. The entire system is designed as a semi-closed loop system. The manipulator is driv...
متن کاملStructure Synthesis of 6-DOF 3-3 Decoupled Parallel Manipulators
In parallel manipulator design, usual 6-DOF PMs, like the Stewart platform, suffer from the disadvantages of difficult forward kinematics, coupled motion, and small workspace, so that the motion planing and control become very complicated and difficult to be implemented in real application. Most of the PMs with lower mobility are over-constrained when assembly errors are considered [1]. Therefo...
متن کاملTracking control of parallel manipulator with 3-DOF
A parallel three degrees of freedom (3-DOF) manipulator known as Maryland manipulator is considered in this paper. The manipulator model considered in this paper is more practical because the offset lengths are not taken zero. The trajectory tracking control of the Maryland manipulator is done using linear–quadratic regulator (LQR) based proportional–integral–derivative (PID) controller. Three ...
متن کاملPlanar Parallel 3-rpr Manipulator
This paper describes the design, construction, and control of a planar three degree-of-freedom (dof) inparallel-actuated manipulator at Ohio University. The actuators are three pneumatic cylinders. Using real-time closed-loop feedback control for each actuator length independently, we develop inverse pose and resolved-rate control for this manipulator. The objective of this work is to implement...
متن کاملOptimal Kinematic Design of a 2-DOF Planar Parallel Manipulator
Closed-form solutions were developed to optimize kinematics design of a 2-degree-of-freedom (2DOF) planar parallel manipulator. The optimum design based on the workspace was presented. Meanwhile, a global, comprehensive conditioning index was introduced to evaluate the kinematic designs. The optimal parallel manipulator is incorporated into a 5-DOF hybrid machine tool which includes a 2-DOF rot...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Mechanical Engineering Research & Developments
سال: 2019
ISSN: 1024-1752
DOI: 10.26480/jmerd.05.2019.57.60