Surface Finishing of Nickel Alloy A-286 by Extrusion Honing Operation
نویسندگان
چکیده
منابع مشابه
Electrochemical finishing of nickel microstructures
One method to manufacture high aspect ratio metallic microstructures is the LIGA technique. The acronym LIGA stands for the German words for lithography, electroforming and moulding. A resist layer (e.g. PMMA) is structured using deep X-ray lithography. The resist is developed and the resulting mould is filled with metal by electroplating. Though electroplating is an essential part of the LIGA ...
متن کاملAmorphous nickel boride membrane on a platinum–nickel alloy surface for enhanced oxygen reduction reaction
The low activity of the oxygen reduction reaction in polymer electrolyte membrane fuel cells is a major barrier for electrocatalysis, and hence needs to be optimized. Tuning the surface electronic structure of platinum-based bimetallic alloys, a promising oxygen reduction reaction catalyst, plays a key role in controlling its interaction with reactants, and thus affects the efficiency. Here we ...
متن کاملBending properties of a new nickel-titanium alloy with a lower percent by weight of nickel.
INTRODUCTION The aim of the present study was to evaluate the bending properties of Hyflex instruments, which exhibit a lower percent in weight of nickel (52 Ni %wt) and compare them with other commercially available nickel-titanium (NiTi) rotary instruments. METHODS Ten instruments with tip size 25, 0.06 taper of each of the following NiTi rotary instrumentation techniques were selected for ...
متن کاملThe Nature of Surface Oxides on Corrosion-Resistant Nickel Alloy Covered by Alkaline Water
A nickel alloy with high chrome and molybdenum content was found to form a highly resistive and passive oxide layer. The donor density and mobility of ions in the oxide layer has been determined as a function of the electrical potential when alkaline water layers are on the alloy surface in order to account for the relative inertness of the nickel alloy in corrosive environments.
متن کاملNumerical Analysis of Az61 Magnesium Alloy Extrusion Process by Modified Equal Channel Angular Extrusion (ecae) Method
T. Bajor, M. Krakowiak, P. Szota, Czestochowa University of Technology, Czestochowa, Poland The paper presents the results of numerical modelling of AZ61 magnesium alloy hot deformation using modified ECAE method. The temperature-velocity conditions were analysed using FEM. The extrusion process was realised using the die with modified angular channel containing horizontal contracting zone in t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Research in Applied Science and Engineering Technology
سال: 2018
ISSN: 2321-9653
DOI: 10.22214/ijraset.2018.7085