Superplasticity and Deformation Induced Grain Growth
نویسندگان
چکیده
منابع مشابه
Deformation-induced grain growth and twinning in nanocrystalline palladium thin films
The microstructure and mechanical properties of nanocrystalline Pd films prepared by magnetron sputtering have been investigated as a function of strain. The films were deposited onto polyimide substrates and tested in tensile mode. In order to follow the deformation processes in the material, several samples were strained to defined straining states, up to a maximum engineering strain of 10%, ...
متن کاملHydrogen-induced transformation superplasticity in zirconium
Commercially-pure zirconium is alloyed and dealloyed repeatedly with hydrogen at 810 C, thereby cyclically triggering phase transformations between hydrogen-free a-Zr and hydrogen-alloyed b-Zr. Under an externally applied tensile stress, the internal mismatch stresses produced by the a-b transformations are biased, resulting in the accumulation of strain increments after each chemical cycle in ...
متن کاملDeformation induced grain rotations in single crystal tantalum
Validation studies of crystal plasticity fi nite element models typically compare model predictions of strain fi elds withexperimental measurements; often ignored are the grain rotations predicted by the model. Accurate predictions ofcrystallographic rotations are necessary for trustworthy predictions of strain fi elds, deformed texture, and failure.This is especially important ...
متن کاملMicrograin Superplasticity: Characteristics and Utilization
Micrograin Superplasticity refers to the ability of fine-grained materials (1 µm < d < 10 μm, where d is the grain size) to exhibit extensive neck-free elongations during deformation at elevated temperatures. Over the past three decades, good progress has been made in rationalizing this phenomenon. The present paper provides a brief review on this progress in several areas that have been relate...
متن کاملDeformation and Grain Growth of Low-Temperature-Sintered High-Purity Alumina
9 = 0.6 I / s ' 7 = 6.0 0 7 = 2 4 i ti 3 = 6 0 Through close control over green-state powder processing, pure alumina ceramics of 0.5-pm grain size were obtained by sintering at 1250°C. The static grain growth of this material was modest at temperatures below 1300°C. However, dynamic grain growth occurred rapidly during superplastic deformation. Therefore, although the ultrafine-grained alumina...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1992
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.78.9_1414