Superplastic deformation behaviours of Zn-22%Al of eutectoid.
نویسندگان
چکیده
منابع مشابه
Superplastic deformation induced by cyclic hydrogen charging
Deformation under the combined action of external stress and cyclic hydrogen charging/discharging is studied in a model material, titanium. Cyclic charging with hydrogen is carried out at 860 °C, which repeatedly triggers the transformation between hydrogen-lean -Ti and hydrogen-rich -Ti. Due to bias from the externally applied tensile stress, the internal mismatch strains produced by this isot...
متن کاملRe-examination of “missing strain” during superplastic deformation of AA7475
Missing strain,” a discrepancy between the total macroscopic strain and the strain contributed by grain boundary sliding (GBS) during superplastic deformation, appears to exist in previous investigations. In this work, the contribution of GBS (ξGBS) and intragranular strain (ξIG) were simultaneously measured using scratch test conducted on AA7475 samples after deformation at 500 °C at initial s...
متن کاملA comparison of failure prediction methods for superplastic deformation
This paper presents a comparison between a number of different failure prediction methods for superplastic forming processes. Attention is limited here to superplastic forming of Ti-6Al-4V at 927C. The failure prediction methods considered include the flow localisation factor approach, forming limit curves based on void growth models, such as the Rice and Tracey model and the Cocks and Ashby mo...
متن کاملHigh Temperature Deformation Behavior of Cr-containing Superplastic Iron Aluminide
Superplastic deformation and high temperature load relaxation behavior of coarse-grained iron aluminides with the composition of Fe-28 at.% Al have been investigated. A series of load relaxation and tensile tests were conducted at temperatures ranging from 600 to 850C. The flow curves obtained from load relaxation tests were found to have a sigmoidal shape and to exhibit stress vs. strain rate ...
متن کاملAchieving microstructures prone to superplastic deformation in an Al - Zn - Mg - Cu alloy by equal channel angular pressing
An Al-Zn-Mg-Cu alloy without Sc or Zr additions was subjected to overaging and processing by equal channel angular pressing, obtaining a grain size of ∼160 nm and a fraction of high-angle boundaries of 56%. The high elongations attained at high strain rate (10-10 s) and low test temperature (250-300 oC) are attributed to the formation of new recrystallized grains, ∼500 nm in size, during heatin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1991
ISSN: 0451-5994
DOI: 10.2464/jilm.41.152