Study on alumina ball size distribution in white cement grinding
نویسندگان
چکیده
This paper presents the results of characterization alumina ball size distribution in mill a crushing and grinding plant. The was unloaded balls were sieved. Then, adjusted to three kinds models; two them are traditional models Rosin-Rammler Gates-Gaudin-Schumann. third model applied Swebrec function, which has been successfully used on fragmented rock distribution. best adjustment for obtained by with correlation coefficient 0.9984.
منابع مشابه
Study of Traverse Grinding Process (1st Report) Accumulation Phenomenon and Size Generation Mechanism in Traverse Grinding
plicated processes on the wheel surf ace along the wheel width. In order to make these processes clear, the experimental analysis of traverse grinding was conducted by widely changing the speed ratio, Kv, the setting depth of wheel, ‡TMT, and the number of total steps, m, (the ratio of the wheel width over the traverse feed per one revolution of the workpiece). The following results were obtain...
متن کاملDensification characteristics of chromia/alumina castables by particle size distribution
The quality of the refractories applied on integrated gasification combined cycle should be a key factor that affects both the reliability and the economics of gasifier operation. To enhance the workability of chromia/alumina castables, three types of ultrafine alumina powder were added to improve the workability. Densification behavior of such castables in the presence of ultrafine alumina was...
متن کاملInvestigation of the Effect of high Alumina Cement on the Properties of Foamed Alumina Insulation Bricks
The purpose of this study was to investigate the effect of high alumina cement and Sintering temperature on microstructure, physical and mechanical properties of foamed alumina insulation bricks. The Slurry samples were prepared containing 75wt% of alumina and 25% wt of deionised water containing 1%, 3%, 5%, 7% wt% high Alumina cement and 2% wt% foam. Then samples were poured into metal molds....
متن کاملGrinding in Ball Mills: Modeling and Process Control
The paper presents an overview of the current methodology and practice in modeling and control of the grinding process in industrial ball mills. Basic kinetic and energy models of the grinding process are described and the most commonly used control strategies are analyzed and discussed.
متن کاملState and Parameter Estimation in Cement Grinding Circuits - Practical Aspects
Due to the lack of reliable and/or inexpensive hardware sensors in cement grinding, development of software sensors is particularly significant for control and monitoring purposes. In this study, a nonlinear distributed-parameter, full-horizon observer is designed, which allows the contents of the mill to be described in terms of hold-up and particle size distribution. When measurements are ava...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Dyna-colombia
سال: 2021
ISSN: ['0012-7353', '2346-2183']
DOI: https://doi.org/10.15446/dyna.v88n218.89805