Structural Modification of Carbon Nanotubes during Ball-milling
نویسندگان
چکیده
منابع مشابه
Conversion of semiconducting behavior of carbon nanotubes using ball milling
This paper proposes a novel chemo-mechanical method to in-situ functionalize carbon nanotubes (CNTs). Ball milling in the presence of ammonium bicarbonate allowed the introduction of amine and amide groups onto the surface of CNTs, resulting in the conversion of the semiconducting behavior of CNTs from p-type to n-type. The corresponding electrical conductivity of CNT increased gradually with b...
متن کاملDefects and Structural Analysis of Multi-Wall Carbon Nano Tubes via Ball milling and Cryo-milling
Nano fillers are part of new studies to enhance various properties of fluids and solids. For example, adding nanoparticles as an enforcement in nanocomposites or as an additive to improve thermal or electrical properties in nano-fluids are of extreme importance in science and industry. There are numerous methods to uniformly disperse nanoparticles in fluid and solid phase. One of the well-used ...
متن کاملEvaluation of catalyst ball-milling process on growth and diameter of carbon nanotubes on iron nanoparticles
In this study, we describe the growth of carbon nanotubes on commercial iron nanoparticles without carbon shell (Fe (nm), size 2O3 and Fe* (nm)/MgO) was carried out by mixing commercial Fe* nanoparticles (as catalyst) with Al2O3 and MgO powders (as supports)by using ball-milling method. The results show in spite of the fact that ball-milling process can have neg...
متن کاملEffect of Initial Aluminum Alloy Particle Size on the Damage of Carbon Nanotubes during Ball Milling
Damage to carbon nanotubes (CNTs) during the fabrication process of CNT reinforced composites has great influence on their mechanical properties. In this study, the 2014 Al with powder sizes of 20, 9 and 5 μm was selected to study the effect of initial particle size on the damage to carbon nanotubes (CNTs) during ball milling. The result shows that for CNTs in the ball milled CNT/Al (with powde...
متن کاملEvaluation of catalyst ball-milling process on growth and diameter of carbon nanotubes on iron nanoparticles
In this study, we describe the growth of carbon nanotubes on commercial iron nanoparticles without carbon shell (Fe (nm), size 2O3 and Fe* (nm)/MgO) was carried out by mixing commercial Fe* nanoparticles (as catalyst) with Al2O3 and MgO powders (as supports)by using ball-milling method. The results show in spite of the fact that ball-milling process can have neg...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Korean Powder Metallurgy Institute
سال: 2013
ISSN: 1225-7591
DOI: 10.4150/kpmi.2013.20.4.258