Structural Characterization of Membrane-Electrode-Assemblies in High Temperature Polymer Electrolyte Membrane Fuel Cells
نویسندگان
چکیده
منابع مشابه
Fabrication of bifunctional membrane electrode assemblies for unitised regenerative polymer electrolyte fuel cells
Introduction: The conversion and storage of energy with a high efficiency, especially a high specific energy, will be an important factor in future energy storage technologies. The relatively simple possibility to store hydrogen and oxygen with high specific energy combined with high energy conversion efficiency in fuel cells and electrolyser presents an opportunity for the use of polymer elect...
متن کاملMaterials and characterization techniques for high-temperature polymer electrolyte membrane fuel cells
The performance of high-temperature polymer electrolyte membrane fuel cells (HT-PEMFC) is critically dependent on the selection of materials and optimization of individual components. A conventional high-temperature membrane electrode assembly (HT-MEA) primarily consists of a polybenzimidazole (PBI)-type membrane containing phosphoric acid and two gas diffusion electrodes (GDE), the anode and t...
متن کاملHigh-Peak-Power Polymer Electrolyte Membrane Fuel Cells
A polymer electrolyte membrane fuel cell with amorphous hydrated ruthenium dioxide (RuO2 " xH2O) supercapacitative sublayers inserted between the electrocatalyst layers and the Nafion membrane was fabricated to enhance the cell’s pulse power output. RuO2 " xH2O material showed a high capacitance ~ca. 230 F/g! and allowed a much higher pulse power output, which was demonstrated by cyclic voltamm...
متن کاملNumerical analysis of reactant transport in the novel tubular polymer electrolyte membrane fuel cells
In present work, numerical analysis of three novel PEM fuel cells with tubular geometry was conducted. Tree different cross section was considered for PEM, namely: circular, square and triangular. Similar boundary and operational conditions is applied for all the geometries. At first, the obtained polarization curve for basic architecture fuel cells was validated with experimental data and then...
متن کاملAl2O3 Disk Supported Si3N4 Hydrogen Purification Membrane for Low Temperature Polymer Electrolyte Membrane Fuel Cells
Reformate gas, a commonly employed fuel for polymer electrolyte membrane fuel cells (PEMFCs), contains carbon monoxide, which poisons Pt-containing anodes in such devices. A novel, low-cost mesoporous Si3N4 selective gas separation material was tested as a hydrogen clean-up membrane to remove CO from simulated feed gas to single-cell PEMFC, employing Nafion as the polymer electrolyte membrane. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of The Electrochemical Society
سال: 2019
ISSN: 0013-4651,1945-7111
DOI: 10.1149/2.0981914jes