Stress Corrosion Cracking of Aluminum Alloy 5052 in 0.82 kmol·m^-3 Aqueous Chloride Solution using SSRT

Effect of Hydrogen on Corrosion and Stress Corrosion Cracking of AZ91 Alloy in Aqueous Solutions

The effect of hydrogen on the corrosion and stress corrosion cracking of the magnesium AZ91 alloy has been investigated in aqueous solutions. Hydrogen produced by corrosion in water diffuses into, and reacts with the Mg matrix to form hydride. Some of the hydrogen accumulates at hydride/Mg matrix (or secondary phase) interfaces as a consequence of slow hydride formation and the incompatibility ...

Direct Electrosynthesis of Polyaniline–Fe2O3 Nanocomposite Coating on Aluminum Alloy 5052 and Its Corrosion Protection Performance

The synthesis of polyaniline- Fe2O3 nanocomposite coating on aluminum Alloy 5052 (AA5052) surface has been investigated by using the galvanostatic method. The anticorrosion performance of polyaniline-Fe2O3 coating was investigated in 3.5% NaCl solution by the open- circuit potential (OCP), Tafel polarization technique and Electrochemical Impedance Spectroscopy (EIS). The corrosion rate of polya...

Stress Corrosion Cracking

Stress-Assisted Corrosion of Aluminum 6061 in Basic Solution

Caustic stress corrosion cracking has only been superficially examined in aluminum alloys. In caustic (basic) environments, the inherent, protective oxide layer becomes soluble on aluminum and allows for further degradation. The purpose of this study is to observe the effect of a strong base solution (sodium, hydroxide, sodium hypochlorite, sodium silicate, pH ~12) on the strength and stress-st...

Stress Corrosion Cracking Detection of Sensitized Stainless Steel 304 in Chloride Media by Using Electrochemical Impedance Spectroscopy (EIS)

Electrochemical impedance spectroscopy (EIS) was used to detect stress corrosion cracking (SCC) in stainless steel 304 alloy exposed to an aqueous environment at 120 °C. Stainless steel 304 alloy as u-bend was tested in the solution that contains 40 weight percent of magnesium chloride. U-bended samples were prepared according to ASTM G30. EIS measurements were always performed simultaneously o...