Strain Age-Hardening of Al Alloys

The Strain Hardening Behaviour of Supersaturated Al-Cu Alloys

Julien da Costa Teixeira, Yves Bréchet , Yuri Estrin and Christopher Hutchinson ARC Centre of Excellence for Design in Light Metals, Department of Materials Engineering, Monash University, Clayton, VIC, 3800, Australia Institut Jean Lamour, Dépt SI2M, Ecole des Mines, Parc de Saurupt, 54042 Nancy, France SIMAP, Institut Nationale Polytechnique de Grenoble, St. Matin D’Hères, 38000, France CSIRO...

Precipitation Hardening of Al–Si–Mg Alloys

Precipitation hardening in dilute Al–Zr alloys

The aim of this study was to investigate the effect of solute content (hipoperitectic Al–0.22 wt.%Zr and hiperperitectic Al–0.32 wt.%Zr) on the precipitation hardening and microstructural evolution of dilute Al–Zr alloys isothermally aged. The materials were conventionally cast in a muffle furnace, solidified in a water-cooled Cu mold and subsequently heat-treated at the temperature of 650 K (3...

SOLUTION STRENGTHENING AND AGE HARDENING CAPABILITY OF Al-Mg-Mn ALLOYS WITH SMALL ADDITIONS OF Cu

Nine Al-(1-3)Mg-(0-0.4)Cu-0.15Si-0.25Mn (in wt%) alloys with potential applications in both packaging and automotive industries have been investigated. Tensile testing showed that solution strengthening is in good approximation linearly proportional to the Mg content. Mechanical testing and microstructural examinations of aged samples indicate that Mg2Si phase precipitates contribute to age har...

Age Hardening of Ultrafine Grained Al-Ti-Cr Alloys Fabricated by Continuous Electron Beam Evaporation

Supersaturated Al-Ti-Cr alloys were produced by a continuous electron beam evaporation technique. The as-deposited alloy sheets were fcc supersaturated solid solution with an average grain size of about 400 nm. Due to the fine grain size, the hardness of the alloy was as high as 270Hv. The sheet showed age hardening, and the peak hardness of 340Hv was obtained after aging at 623K for 900 s, in ...