Spray Etching Rate Development of Stainless Steel in the Etchant for Printed Circuit Heat Exchanger Channels

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Review Heat Exchanger: Research Development of Self-rotating Inserts in Heat Exchanger Tubes

Heat exchangers are widely used in power engineering and industrial applications, many techniques such as coiled tube, surface tension devices, rough surfaces, extended surfaces have been investigated to enhancethermal performance and to minimize the cost and size of the heat exchanger equipment. One of the most important techniques is tube insert. In general,tube inserts can be classified into...

متن کامل

study of cohesive devices in the textbook of english for the students of apsychology by rastegarpour

this study investigates the cohesive devices used in the textbook of english for the students of psychology. the research questions and hypotheses in the present study are based on what frequency and distribution of grammatical and lexical cohesive devices are. then, to answer the questions all grammatical and lexical cohesive devices in reading comprehension passages from 6 units of 21units th...

Heat Management in Printed Circuit Boards

This report discusses the significance of heat management in the design of printed circuit boards (PCB). After an introduction into the basics of PCBs the crucial mechanisms of heat transfer are discussed with regard to significance and typical design parameters. Emphasis is laid on ways to determine conductive heat transfer. Here, common techniques as well as considerations on how to model PCB...

متن کامل

Self-terminating electrochemical etching of stainless steel for the fabrication of micro-mirrors

A novel, self-terminating electrochemical etch process is proposed for the fabrication of scanning steel micro-mirrors. The process uses single mask photolithography, and the etching step is terminated automatically, which at the same time enables the depth profile shaping of the fabricated structure. The proposed process is characterized and then used to fabricate two versions of one-dimension...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Energy Procedia

سال: 2017

ISSN: 1876-6102

DOI: 10.1016/j.egypro.2017.03.957