Sintered Fe-P-C Wear Resistant Material for Apex Seal of Rotary Engine
نویسندگان
چکیده
منابع مشابه
Apex Seals for a MEMS Rotary Engine
This paper presents possible solutions to the problem of leakage in the MEMS rotary engine currently being developed at U.C. Berkeley. The project is motivated by the challenge to develop a system capable of a higher specific energy than primary batteries. Currently, leakage is the limiting factor in obtaining an engine with an acceptable efficiency. Fluidic analysis has been done to determine ...
متن کاملSintered hydroxyapatite ceramic for wear studies.
A sintered hydroxyapatite (HAP) ceramic for use in wear studies was prepared from a commercial tricalcium phosphate. The sintered HAP had physical properties close to those of human enamel. The coefficient of friction and wear of the sintered HAP ceramic as characterized by tangential force, track width, and surface failure data, approximated those of human enamel.
متن کاملEmissions from a Diesel Engine using Fe-based Fuel Additives and a Sintered Metal Filtration System.
A series of laboratory tests were conducted to assess the effects of Fe-containing fuel additives on aerosols emitted by a diesel engine retrofitted with a sintered metal filter (SMF) system. Emission measurements performed upstream and downstream of the SMF system were compared, for cases when the engine was fueled with neat ultralow sulfur diesel (ULSD) and with ULSD treated with two formulat...
متن کاملMaterial Flow in Rotary Drums
The experimental investigation of material flow in rotary drums is studied. An equipment in the size of pilot-scale was used to collect experimental data for investigation of validity of the conventional steady-state model of material flow in rotary drums. Also, the transient data of the time required for material movement in the empty drum up to any specified cross section are also reported. T...
متن کاملImpulse Magnetization of Nd-Fe-B Sintered Magnets for Sensors
Magnetization of large Nd-Fe-B sintered permanent magnets is still challenging. This type of permanent magnet is electrically conductive, so impulse magnetization causes a flow of eddy currents which prevent magnetization of the whole volume of the magnet. The paper deals with the impulse magnetization of sintered Nd-Fe-B permanent magnets and shows a method for the determination of suitable pa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2003
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.50.757