Singular Stress Fields near a Corner of Jointed Dissimilar Materials.
نویسندگان
چکیده
منابع مشابه
Control of Welding Residual Stress for Dissimilar Laser Welded Materials
The most common problem of welding dissimilar metals (DMWs) with respect to residual stresses is the differences in the coefficient of thermal expansion and heat conductivity of the two welded metals. In the present work, a CO2 continuous laser welding process was successfully applied and optimized for joining a dissimilar AISI 316 stainless steel and low carbon steel plates. The Taguchi approa...
متن کاملEffect of Adhesive Thickness on the Intensity of Singular Stress at the Adhesive Dissimilar Joint*
Abstract This paper deals with the singular stress field at the adhesive dissimilar joint, and discusses the effect of material combination and adhesive thickness on the intensity of the singular stress when bonded strip is subjected to tension. A useful method to calculate the intensity of singular stress at the adhesive dissimilar joint is presented with focusing on the stresses at the edge c...
متن کاملInfluences of non-singular stresses on plane-stress near-tip fields for pressure-sensitive materials and applications to transformation toughened ceramics
In this paper, we investigate the effects of the non-singular stress (T stress) on the mode I near-tip fields lbr elastic perfectly plastic pressure-sensitive materials under plane-stress and small-scale yielding conditions. The T stress is the normal stress parallel to the crack faces. The yield criterion for pressure-sensitive materials is described by a linear combination of the effective st...
متن کاملNear-Optimal Controls of a Fuel Cell Coupled with Reformer using Singular Perturbation methods
A singularly perturbed model is proposed for a system comprised of a PEM Fuel Cell(PEM-FC) with Natural Gas Hydrogen Reformer (NG-HR). This eighteenth order system is decomposedinto slow and fast lower order subsystems using singular perturbation techniques that provides tools forseparation and order reduction. Then, three different types of controllers, namely an optimal full-order,a near-opti...
متن کاملMicro-Study of Dissimilar Welded Materials
The dissimilar joint between aluminum/titanium alloys (Al 6082 and Ti G2) were successfully achieved by CO2 laser welding with a single pass and without filler material using the overlap joint design. Laser welding parameters ranges combinations were experimentally determined using Taguchi approach with the objective of producing welded joint with acceptable welding profile and high quality of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1991
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.57.2509