Singular Stress Field in Two Bonded Wedges.
نویسندگان
چکیده
منابع مشابه
Intensity of Singular Stress Field at the Corner of Adhesive Layer in Bonded Plate
In this paper the strength of adhesive joint under tension and bending is discussed on the basis of intensity of singular stress by the application of FEM. A useful method is presented with focusing on the stress at the edge of interface between the adhesive and adherent obtained by FEM. After analyzing the adhesive joint strength with all material combinations, it is found that to improve the ...
متن کاملScrew Dislocation Interacting with an Interfacial Edge Crack between Two Bonded Dissimilar Piezoelectric Wedges
This letter is concerned with an interfacial edge crack in a piezoelectric bimaterial wedge interacting with a screw dislocation under antiplane mechanical and in-plane electric loading. In addition to a discontinuous electric potential across the slip plane, the dislocation is subjected to a line-force and a line-charge at the tip. The out-of-plane displacement and electric potentials are obta...
متن کاملAnalytical Solution of Stress Field in Adhesively Bonded Composite Single-Lap Joints Under Mechanical Loadings
In this paper, considering an adhesively bonded composite single-lap joint, a novel approach is presented to predict the peel and shear stress distributions of the adhesive layer for an ASTM standard test sample. In current method, the equilibrium equations are derived using the energy method and based on the Timoshenko’s beam theory. Two solution procedures then are discussed, one of which rep...
متن کاملCollision of Two Liquid Wedges
1. INTRODUCTION Splashing following the collisions of liquids or granular materials is often observed in a variety of natural and engineering problems, such as plunging or breaking water waves, liquid droplets impacting on a free surface or a thin film of the same liquid, etc. Splashing leads to fluid fragmentation and the generation of drops and spray as well as fluid aeration. These phenomena...
متن کاملThermal Stress in Bonded Joints
This paper considers the stress distributions in bonded materials induced by differential expansion or contraction of these materials. The analytical approach is similar to the lap joint theories attributed to Volkersen and expanded by Goland and Reissner. Several simple and typical analytical models are presented to bring out the relative importance of dlrerent geometrical and material paramet...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1992
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.58.457