Short fiber-elastomer composites. 4. The distribution of ingredients in elastomer component for short fiber-elastomer composites.

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Ionically Bonded Filler-Elastomer Composites*

Tertiary amine-modified corn starches were converted to their basic or hydroxide form and combined with carboxylated butadiene-acrylonitrile copolymer and butadiene-styrene-sulfonic acid polymer to produce ionically bonded filler-elastomer composites. An increasing percentage of the elastomer fraction in the starch-elastomer composite is insolubilized as the starch-to-elastomer ratio increases....

متن کامل

Nanoparticle-Liquid Crystalline Elastomer Composites

Liquid crystalline elastomers (LCEs) exhibit a number of remarkable physical effects, including a uniquely high-stroke reversible mechanical actuation triggered by external stimuli. Fundamentally, all such stimuli affect the degree of liquid crystalline order in the polymer chains cross-linked into an elastic network. Heat and the resulting thermal actuation act by promoting entropic disorder, ...

متن کامل

Structural Dynamics and Interfacial Properties of Elastomer Nano-composites

The combined effect of filler networking and reduced chain mobility close to the filler interface on the dynamic-mechanical properties of elastomers is analyzed based on investigations of the relaxation dynamics of solution styrene butadiene rubber filled with different loadings of silica. Dynamic-mechanical and dielectric spectra are studied in a wide frequency and temperature range. For the c...

متن کامل

Elastomeric Origami: Programmable Paper-Elastomer Composites as Pneumatic Actuators

This paper describes the development of soft pneumatic actuators based on composites consisting of elastomers with embedded sheet or fiber structures (e.g., paper or fabric) that are flexible but not extensible. On pneumatic inflation, these actuators move anisotropically, based on the motions accessible by their composite structures. They are inexpensive, simple to fabricate, light in weight, ...

متن کامل

An Investigation of the Fatigue Induced Failure Modes of Fiber/Elastomer Composites as Bearing Surfaces in Total Hip Joint Prosthesis

It is proposed to use elastomeric composites as artificial joint bearing surfaces to increase their fluid film lubrication and therefore reduce the number of failures which have been attributed to wear mechanisms related to frictional forces. The fluid generated between the surfaces supports part of the load and prevents direct contact of the bearing surfaces. In order to obtain optimum elastoh...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: NIPPON GOMU KYOKAISHI

سال: 1985

ISSN: 1884-0442,0029-022X

DOI: 10.2324/gomu.58.721