Serial 100 Gb/s connectivity based on polymer photonics and InP-DHBT electronics
نویسندگان
چکیده
منابع مشابه
Serial 100 Gb/s connectivity based on polymer photonics and InP-DHBT electronics.
We demonstrate the first integrated transmitter for serial 100 Gb/s NRZ-OOK modulation in datacom and telecom applications. The transmitter relies on the use of an electro-optic polymer modulator and the hybrid integration of an InP laser diode and InP-DHBT electronics with the polymer board. Evaluation is made at 80 and 100 Gb/s through eye-diagrams and BER measurements using a receiver module...
متن کاملInP DHBT technology for 100 Gbit/s applications
TECHNOLOGY In this paper, we report a manufacturable InP DHBT technology, suitable for medium scale mixed-signal and monolithic microwave integrated circuits. The MBE grown InP-based DHBTs with an emitter area of 1 × 4 μm exhibited peak cutoff frequencies (fT and fMAX) > 300 GHz, and a breakdown voltage (BVCEo) of ~ 5 V. The InP DHBT layer structures were grown on 3” semiinsulating InP substrat...
متن کاملInP DHBT-Based IC Techno Data Communi
In this paper, we report the achieved performance of devices and integrated circuits (ICs) using a manufacturable InP DHBT-based technology. High speed MBE grown InGaAs/InP DHBTs with an effective emitter junction area of 4.8 μm exhibited peak fT and fMAX values of 265 and 305 GHz, respectively, at a collector current density of 3.75 mA/μm. Using this technology, a set of basic analog and digit...
متن کاملMillimeterwave INP DHBT power amplifier based on poweroptimized cascode configuration
This letter describes the use of a power-optimized cascode configuration for obtaining maximum output power at millimeter-wave (mm-wave) frequencies for a two-way combined power amplifier (PA). The PA has been fabricated in a high-speed InP double heterojunction bipolar transistor technology and has a total active emitter area of 68.4 lm2. The experimental results demonstrate a small signal gai...
متن کامل140-220 GHz Imaging Front-end Based on 250 nm InP/InGaAs/InP DHBT Process
This paper presents a pre-amplified detector receiver based on a 250 nm InP/InGaAs/InP double heterojunction bipolar transistor (DHBT) process available from the Teledyne scientific. The front end consists of a double slot antenna followed by a five stage low noise amplifier and a detector, all integrated onto the same circuit. Results of measured responsivity and noise are presented. The recei...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Optics Express
سال: 2012
ISSN: 1094-4087
DOI: 10.1364/oe.20.028538