Selective catalytic transformation of polystyrene into ethylbenzene over Fe-Cu-Co/Alumina
نویسندگان
چکیده
منابع مشابه
Catalytic Gas-Phase Glycerol Processing over SiO2-, Cu-, Ni- and Fe- Supported Au Nanoparticles
In this study, we investigated different metal pairings of Au nanoparticles (NPs) as potential catalysts for glycerol dehydration for the first time. All of the systems preferred the formation of hydroxyacetone (HYNE). Although the bimetallics that were tested, i.e., Au NPs supported on Ni, Fe and Cu appeared to be more active than the Au/SiO2 system, only Cu supported Au NPs gave high conversi...
متن کاملCatalytic transformation of ethanol into 1,3-butadiene
1,3-Butadiene is an important constituent of many products that we rely upon. It is currently prepared from non-sustainably derived sources. However, in the early part of the 20(th) Century the use of ethanol as a source of 1,3-butadiene has been reported. With the arrival of a cheap and bountiful supply of crude-oil derived sources the need for the sustainable route was deemed unnecessary. In ...
متن کاملCatalytic oxidation of toluene over LaBO3 (B= Fe, Mn and Co) and LaCo0.7B′0.3O3 (B′= Fe and Mn) perovskite-type
In this paper, LaBO3 perovskite type catalyst formulations were prepared by sol-gel auto combustion method using citric acid as the fuel. Activity of catalysts was tested in catalytic oxidation of toluene as a model of volatile organic compounds. LaCoO3 perovskite formulation showed the highest activity among LaBO3 (Fe, Mn and Co) perovskite catalysts. So, LaCoO3 perovskite based catalyst was s...
متن کاملCatalytic Decomposition of N2O over Cu–Zn/ZnAl2O4 Catalysts
The catalytic decomposition of N2O was investigated over Cu-Zn/ZnAl2O4 catalysts in the temperature range of 400–650 ◦C Catalytic samples have been prepared by wet impregnation method. Prepared catalysts were characterized using several techniques like BET surface area, X-ray diffraction (XRD), and Scanning electron microscopy (SEM). The Cu-Zn/ZnAl2O4 showed higher catalytic performance along w...
متن کاملThe Effect of Temperature on Product Distribution over Fe-Cu-K Catalyst in Fischer-Tropsch Synthesis
The iron-based catalyst was prepared by a microemulsion method. The composition of the final nanosized iron catalyst, in terms of the atomic ratio, contains 100Fe/4Cu/2K. The experimental techniques of XRD, BET, TEM, and TPR were used to study the phase, structure, and morphology of the catalyst. Fischer-Tropsch synthesis (FTS) reaction test was performed in a fixed bed reactor under pressure o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Saudi Chemical Society
سال: 2020
ISSN: 1319-6103
DOI: 10.1016/j.jscs.2020.01.008