Root stresses of thin-rimmed spur gears due to press-fitting.
نویسندگان
چکیده
منابع مشابه
Influence of Addendum Modification Factor on Root Stresses in Normal Contact Ratio Asymmetric Spur Gears
Tooth root crack is considered as one of the crucial causes of failure in the gearing system and it occurs at the tooth root due to an excessive bending stress developed in the root region. The modern power transmission gear drives demand high bending load capacity, increased contact load capacity, low weight, reduced noise and longer life. These subsequent conditions are satisfied by the aid o...
متن کاملEffect of Shaft Misalignment on The Stresses Distribution of Spur Gears
Dr. Hani Aziz Ameen* Received on :17/8/2009 Accepted on:7/1/2010 Abstract Shaft misalignment is considered as one of the common repeated problems in most rotating machineries , which leads to generate vibrations and extra dynamic loads on transmitting gears teeth, also leads to nonuniformity in distribution of applied load along the meshing tooth face by being concentrated on one side of tooth ...
متن کاملThe source of Acoustic Emission during meshing of spur gears
Condition monitoring of gears with vibration analysis and Spectrometric Oil Analysis Programs (SOAP) are widely accepted and used in the military aviation industry. Whilst the literature to date has shown the application of the Acoustic Emission (AE) technique to gearbox health monitoring still be in its infancy, there exist opportunities to develop the technique into a complementary diagnostic...
متن کاملInfluence of dynamic behaviour on elastohydrodynamic lubrication of spur gears
In this study, the elastohydrodynamic lubrication (EHL) behaviour of high-speed spur gear contacts is investigated under dynamic conditions. A non-linear time-varying vibratory model of spur gear pairs is introduced to predict the instantaneous tooth forces under dynamic conditions within both the linear and non-linear operating regimes. In this model, the periodically time-varying gear mesh st...
متن کاملEfficiency and Temperature of Spray Lubricated Superfinished Spur Gears
Gearboxes are one of the most power dense systems used today, and in certain instances their limiting factor is the ability to evacuate heat from the gear contact. This work analyses the efficiency (i.e. heat generation) and tooth temperature in the three lubricating conditions dip, into mesh spray and out of mesh spray for superfinished gears which are then compared to ground gears. A back-to-...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. 3, Vibration, control engineering, engineering for industry
سال: 1990
ISSN: 0914-8825
DOI: 10.1299/jsmec1988.33.238