Reversibly compressible and freestanding monolithic carbon spherogels
نویسندگان
چکیده
منابع مشابه
Parallel monolithic implicit solver for compressible flows
This paper introduces a monolithic compressible flow implicit scheme, capable of scaling up to a few thousand processors. The scheme is programmed in Alya, the BSC in-house code for simulating multiphysics problems in supercomputers [1,2,3]. It is monolithic, assembling a global matrix for the delta form of the conservative unknowns linear momentum, density and total energy and solving the resu...
متن کاملHigh performance, freestanding and superthin carbon nanotube/epoxy nanocomposite films.
We develop a facile, effective and filter free infiltration method to fabricate high performance, freestanding and superthin epoxy nanocomposite films with directly synthesized Sing-Walled Carbon Nanotubes (SWNTs) film as reinforcement skeleton. It is found that the thicknesses of the nanocomposite films can be easily controlled in the range of 0.5-3 μm by dripping target amount of acetone dilu...
متن کاملSuper-compressible foamlike carbon nanotube films.
We report that freestanding films of vertically aligned carbon nanotubes exhibit super-compressible foamlike behavior. Under compression, the nanotubes collectively form zigzag buckles that can fully unfold to their original length upon load release. Compared with conventional low-density flexible foams, the nanotube films show much higher compressive strength, recovery rate, and sag factor, an...
متن کاملRaman modes of index-identified freestanding single-walled carbon nanotubes.
Using electron diffraction on freestanding single-walled carbon nanotubes, we have determined the structural indices (n,m) of tubes in the diameter range from 1.4 to 3 nm. On the same freestanding tubes, we have recorded Raman spectra of the tangential modes and the radial breathing mode. For the smaller diameters (1.4-1.7 nm), these measurements confirm previously established radial breathing ...
متن کاملFabrication and characterization of nanotemplated carbon monolithic material.
A novel hierarchical nanotemplated carbon monolithic rod (NTCM) was prepared using a novel facile nanotemplating approach. The NTCM was obtained using C60-fullerene modified silica gels as hard templates, which were embedded in a phenolic resin containing a metal catalyst for localized graphitization, followed by bulk carbonization, and template and catalyst removal. TEM, SEM, and BET measureme...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Carbon
سال: 2019
ISSN: 0008-6223
DOI: 10.1016/j.carbon.2019.06.086