Residual thermal stresses in injection molded products
نویسندگان
چکیده
منابع مشابه
Thermal Processing of Injection-Molded Silicon Carbide
Silicon carbide is the most important and versatile non-oxide ceramic. Powder injection molding (PIM) is a method of high-speed fabrication of complex near-net shapes of SiC and other powders. Green micro-machining (GMM) is used to extend the shaping capability of green ceramics and powder metallurgy to smaller feature sizes. Debinding—removal of organic additives—is the rate-limiting step in P...
متن کاملPrediction of residual stresses in injection moulded parts
For automotive plastic parts, mostly used for interior assemblies, there is a clear demand of an increased accuracy of the simulation model. One crucial input for the simulation model is the correct material data. Based on test data, it is known that the dynamic material properties of a plastic part can differ significantly from the material data given in the data sheet (which is based on a spe...
متن کاملThermal gradients and residual stresses in veneered Y-TZP frameworks.
OBJECTIVES The occurrence of "chipping" of all-ceramic restorations with Y-TZP frameworks has resulted in various designs and cooling procedures recommended for reducing such behavior. In this paper the temperature gradients during fast and slow cooling for conventional and anatomical designs are compared as well as an optical procedure to directly compare the influence of cooling rate on resid...
متن کاملNumerical Study on Residual Thermal Stresses in Carbon Fibre Pullout
This paper investigated the effect of residual thermal stresses on carbon fibre pullout by using cohesive zone modelling. The finite element method was applied to analyse the residual thermal stress components along the interface between the fibre and matrix due to curing. A comparison study on the anisotropic and isotropic material properties are considered using four typical carbon fibres, T3...
متن کاملStudy on residual stresses of thin-walled injection molding
The residual stresses of the thin-walled injection molding are investigated in this study. It was realized that the behavior of residual stresses in injection molding parts was affected by different process conditions such as melt temperature, mold temperature, packing pressure and filling time. The layer removal method was used to measure the residual stresses at a thin-walled test sample by a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymer Engineering & Science
سال: 1996
ISSN: 0032-3888,1548-2634
DOI: 10.1002/pen.10585