منابع مشابه
Microstructures and Mineralogy of Deformation Bands in Drill Cores from the Matzen Hydrocarbon Reservoir, Austria
.................................................................................................................................................................. 4 ZUSAMMENFASSUNG .............................................................................................................................................. 6 INTRODUCTION..............................................................
متن کاملPetrophysical Properties of Twenty Drill Cores from the Los Azufres, Mexico, Geothermal Field
For this study we selected 20 drill cores covering a wide range of depths (400-3000 m), from 15 wells, that provide a reasonable coverage of the field. Only andesite, the largely predominant rock type in the field, was included in this sample. We measured bulk density, grain (solids) density, effective porosity and (matrix) permeability on a considerable number of specimens taken from the cores...
متن کاملGeology and geochemistry of shallow drill cores from the Bosumtwi impact structure, Ghana
available online at http://meteoritics.org 1137 © Meteoritical Society, 2003. Printed in USA. Geology and geochemistry of shallow drill cores from the Bosumtwi impact structure, Ghana Daniel BOAMAH† and Christian KOEBERL* Department of Geological Sciences, University of Vienna, Althanstrasse 14, A-1090 Vienna, Austria †Present address: Ghana Geological Survey Department, P.O. Box M80, Accra, Gh...
متن کاملResidual Stress Variation in Polysilicon Thin Films
This paper compares the use of four mechanical methods for characterization of residual stress variation in low pressure chemical vapor deposited (LPCVD) polysilicon thin films deposited, doped, and annealed under different conditions. Stress was determined using buckling structures, vibrating microstructures, static rotating structures and the wafer curvature method. After deposition of 1.0 μm...
متن کاملResidual Stress, Stress Relief, and Inhomogeneity in Aluminum Plate
Through-thickness residual-stress profiles in rolled 7050-T74 aluminum plate were measured before and after stress relief by stretching (-Tx51). Measurement required adapting the crack compliance method to measure both inplane stress components. Unexpected features in the profiles could be explained by through-thickness yield strength variations caused by crystallographic texture.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Geophysical Journal International
سال: 1989
ISSN: 0956-540X,1365-246X
DOI: 10.1111/j.1365-246x.1989.tb02046.x