Research and Development for Dust Removal on Diesel Engine (Part-1)
نویسندگان
چکیده
منابع مشابه
Development and Use of LES for Diesel Engine CFD
Large eddy simulation is a promising advancement for IC engine modeling. This requires appropriate models for a many physical processes. This paper classifies and briefly describes the major types of models for turbulence, combustion, and sprays. Representative references are listed with an emphasis on engine applications. Recommendations for modeling approaches to use in engine LES are also pr...
متن کاملDevelopment of balance shaft and flywheel for single cylinder diesel engine based on analytical approach and comparison with the simulation result
Vibration is a key factor of abrasion and destruction in the internal combustion engine. In internal combustion engines, the main causes of vibration is combustion pressure, connecting rod weight, piston weight and inertial forces. This vibration create corrosion and fracture in main part of engine such as crankshaft, camshaft and cylinder block in long time. This corrosion and fracture is effe...
متن کاملStudy on the Testing Method for Marine Diesel Engine
For the high-power low-speed diesel engine’s performance and reliability evaluation, this paper studies the engine’s running-in norms, presents the Test Scheme about the combustion process, the Inlet swirl control, the cooling system control, and the distribution and emission. The whole engine’s test methods and systems are established. By using the combined method of the test platform research...
متن کاملImproved Controller Design for Turbocharged Diesel Engine
Turbocharged diesel engines are now being used in every automobile by a lot of automobile manufacturing companies. A turbocharged diesel engine (TDE) equipped with variable geometry turbocharger and exchange gas recirculation is explained in detail. A linear turbocharged diesel engine model is presented and its control techniques are explained in detail. Controllers are designed using the linea...
متن کاملCombustion Improvement for Reducing Exhaust Emissions in DI Diesel Engine
Multidimensional modelling of open-cycle process of OM355 engine was developed. Calculations for computational mesh were carried out. The results of the model were validated by experimentally measured in-cylinder pressure and the good agreement between calculations and measurements approved the trustworthy of numerical code. Results included pressure, temperature, emission and Rate of heat rel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF THE MARINE ENGINEERING SOCIETY IN JAPAN
سال: 1996
ISSN: 0388-3051,1884-4758
DOI: 10.5988/jime1966.31.883