Remotely-Controlled Low-Cost Digital Telescope
نویسندگان
چکیده
منابع مشابه
Low-cost digital subtraction angiography.
Intravenous angiography was an important diagnostic tool earlier in th is century [1] , however, the technique had many drawbacks . Film timing was critical, the volume of contrast material was high , and the contrast resolution was often poor. When safer techniques for direct arteriography were developed, intravenous angiography was abandoned . Computed digital image processing has brought a r...
متن کاملLow Cost Digital Vibration Meter
This report describes the development of a low cost, digital Micro Electro Mechanical System (MEMS) vibration meter that reports an approximation to the RMS acceleration of the vibration to which the vibration meter is subjected. The major mechanical element of this vibration meter is a cantilever beam, which is on the order of 500 µm in length, with a piezoresistor deposited at its base. Vibra...
متن کاملLow - Cost Digital Cameras : Calibration , Stability
....................................................................................................................... ii ACKNOWLEDGEMENTS............................................................................................... iii DEDICATION................................................................................................................... iv TABLE OF CONTENTS...............
متن کاملLow Cost Nonrecursive Digital Filter Structures
This paper presents a novel method of hardware reduced fast FIR filter structure for parallel data processing.In general, arithmetic operation modules such as adder and multiplier modules, consume much power, energy, and circuit area. The power consumed by the adder structure is also very significant while designing a low power filter. The proposed low power multipliers and low power adders are...
متن کاملLow Cost, Audio Speed Digital Oscilloscope
The goal of the project was to design a low-cost digital oscilloscope targeted at students, hobbyists, and researchers. The requirements of the oscilloscope were three-fold: 1) cost less than $100, 2) capture frequencies over the range 20Hz–20kHz, and 3) constructable with a basic soldering iron and limited soldering skills. The primary parts of the oscilloscope are two Atmel ATmega644 microcon...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering Journal
سال: 2019
ISSN: 0125-8281
DOI: 10.4186/ej.2019.23.3.141