Recent Trend of Development of Cutting Tools. CVD Coated Carbide Tools. Throw-away Tip.
نویسندگان
چکیده
منابع مشابه
Cutting Force Prediction in End Milling Process of AISI 304 Steel Using Solid Carbide Tools
In the present study, an attempt has been made to experimentally investigate the effects of cutting parameters on cutting force in end milling of AISI 304 steel with solid carbide tools. Experiments were conducted based on four factors and five level central composite rotatable design. Mathematical model has been developed to predict the cutting forces in terms of cutting parameters such as he...
متن کاملCVD diamond coatings on geometrically complex cutting tools
The manufacturing of chemical vapour deposition (CVD) diamond coated shaft type cutting tools is demanding due to the complex design of the cutting edges and the cobalt content of the cemented carbide. The influencing parameters of substrate, pre-treatment and diamond film on the tool cutting performance are discussed. The optimised manufacturing route of CVD diamond coated thread milling drill...
متن کاملWear behavior of ZrAlN coated cutting tools during turning
In this study we explore the cutting performance of ZrAlN coatings. WC:Co cutting inserts coated by cathodic arc evaporated Zr1-xAlxN coatings with x between 0 and 0.83 were tested in a longitudinal turning operation. The progress of wear was studied by optical microscopy and the used inserts were studied by electron microscopy. The cutting performance was correlated to the coating composition ...
متن کاملRecent development of molecular tools for pathogen
detection introduced the possibility of early targeted antimicrobial treatment that, in turn, may improve the outcome of patients with sepsis [1]. We retrospectively evaluated 54 results of the SeptiFast test from patients with solid malignancy admitted to the ICU between June 2009 and August 2011. Specimens from suspected bloodstream infection were analyzed using LightCycler SeptiFast (Roche M...
متن کاملSingle Point Diamond Turning of CVD coated Silicon Carbide
Scratching experiments, using diamond styli and single point diamond tools, were performed to simulate Single Point Diamond Turning (SPDT). The results of these experiments were used to determine if a ductile response is possible, and then to determine the critical depth of cut or penetration depth for the ductile to brittle transition (DBT). The depths of the scratches produced at different lo...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1995
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.61.773