Reaction Process in the Ni-SDC Cermet Anode
نویسندگان
چکیده
منابع مشابه
Tribological Properties of B4C-Ni Cermet Coating Produced by HVOF Process on the Surface of 4130 Steel
In this research, B4C-Ni cermet coating was sprayed on the surface of 4130 steel from B4C and Ni feed-stockpowders using high velocity oxy-fuel (HVOF) method. In order to characterize the tribological behavior of thecoating, ball on disk wear tests were done at the ambient temperature and under the loads of 1, 3 and 5 N.Phase analysis of the coating after spraying was studied ...
متن کاملElectrodeposition of Cu into a Highly Porous Ni/YSZ Cermet
The electrochemical deposition of Cu into 0.12 cm and 60 μm thick, highly porous 65 vol % Ni/yttriastabilized zirconia (YSZ) cermets was investigated. An electrochemical cell in which the electrolyte solution was allowed to flow through a porous Ni/YSZ substrate was used to eliminate mass-transfer limitations and to determine the conditions for which the potential drop in the electrolyte soluti...
متن کاملEFFECT OF RHODIUM INFILTRATION ON THE MICROSTRUCTURE AND PERFORMANCE OF Ni/Ce0.8Gd0.2O2-δ CERMET ANODE FOR LOW TEMPERATURE SOLID OXIDE FUEL CELL
In order to further enhance the Ni/Ce 0.8Gd0.2O2-δ (Ni/GDC20) cermet anodic performance for low temperature solid oxide fuel cell (LT-SOFC), a study was conducted on the nanostructuring of NiO/GDC composite by only once wet-infiltration of rhodium chloride precursor. By using electrochemical impedance spectroscopy (EIS) analysis, the effect of only one drop of Rh-infiltrating solution on ...
متن کاملtribological properties of b4c-ni cermet coating produced by hvof process on the surface of 4130 steel
in this research, b4c-ni cermet coating was sprayed on the surface of 4130 steel from b4c and ni feed-stockpowders using high velocity oxy-fuel (hvof) method. in order to characterize the tribological behavior of thecoating, ball on disk wear tests were done at the ambient temperature and under the loads of 1, 3 and 5 n.phase analysis of the coating after spraying was studied by x-ray diffracto...
متن کاملNanostructuring Platinum Nanoparticles on Ni/Ce0.8Gd0.2O2-δ Anode for Low Temperature Solid Oxide Fuel Cell via Single-step Infiltration: A Case Study
With the aim of promoting the Ni/Ce0.8Gd0.2O2-δ (Ni/GDC20) cermet anodic performance of low temperature solid oxide fuel cell (LT-SOFC) [1], nanostructuring platinum nanoparticles on NiO/GDC composite was done by single-step wet-infiltration of hexachloroplatinic acid hexahydrate (H2PtCl6.6H2O) precursor on NiO/GDC20 composite. The anodic polarization resistance was measured using symmetr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Electrochemistry
سال: 2009
ISSN: 2186-2451,1344-3542
DOI: 10.5796/electrochemistry.77.190