Rapid solidification processing of aluminum alloys.
نویسندگان
چکیده
منابع مشابه
Contraction of Aluminum Alloys during and after Solidification
A technique for measuring the linear contraction during and after solidification of aluminum alloys was improved and used for examination of binary and commercial alloys. The effect of experimental parameters, e.g., the length of the mold and the melt level, on the contraction was studied. The correlation between the compositional dependences of the linear contraction in the solidification rang...
متن کاملRapid solidification behavior of Zn-rich Zn–Ag peritectic alloys
Rapid solidification experiments, including laser remelting, melt-spinning and wedge casting, were carried out to investigate the rapid solidification behavior of Zn-rich Zn–Ag peritectic alloys containing up to 9.0 at% Ag. For comparison, Bridgman solidification experiments of the same alloys were also carried out for growth velocities ranging from 0.02 to 4.82 mm/s, which were lower than that...
متن کاملA thermomechanical study of the effects of mold topography on the solidification of Aluminum alloys
A thermomechanical study of the effects of mold topography on the solidification of Aluminum alloys at early times is provided. The various coupling mechanisms between the solid-shell and mold deformation and heat transfer at the mold/solid-shell interface during the early stages of Aluminum solidification on molds with uneven topographies are investigated. The air-gap nucleation time, the stre...
متن کاملFriction Stir Processing of Aluminum Alloys: A Literature Survey
Many aluminum alloys with specific properties, like high strength, suffers from certain limitations in terms of cost and time of production, apart from the reduction in ductility. High strength accompanied by high ductility is possible with materials having fine and homogenous grain structures. Hence there arises a necessity to develop a processing technique that would produce a material with s...
متن کاملSolidification Mechanism of Hickly Undercooled Metal Alloys
This paper describes the results of experiments on metal droplet undercooling, and presents a preliminary analysis of the structures obtained. Work was conducted with Sn-25wt%Pb and Ni-34wt%Sn alloys. To achieve the required high degrees of undercooling, emuls i fication treatments were utilized following techniques described-by Perepezko and co-workers. Experiments show the fraction of supersa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 1989
ISSN: 0451-5994
DOI: 10.2464/jilm.39.514