Pulse electrodeposition and corrosion properties of Ni–Si3N4 nanocomposite coatings

Corrosion Protection Performance of Nanoclay-Polyester Nanocomposite Coatings

In this paper, polymer-based nanocomposites powder were applied on the surface of plain carbon steel by electrostatic device and then were cured by microwave. The effect of adding nanoparticles on the corrosion resistance properties of the coatings was investigated by Electrochemical Impedance Spectroscopy and immersion test in 3.5 NaCl solution. Coatings structure and morphology of nanoparticl...

Hard Nanocomposite Coatings , Their Structure and Properties

Graphene nanocomposite coatings for protecting low-alloy steels from corrosion

facturing methods. Graphene nanocomposite coatings for protecting lowalloy steels from corrosion A ceramic engineer or scientist unfortunately must admit that there is an unwelcome member of the family among us—iron oxide, or rust. This unpleasant family member is disruptive at best. More often it is destructive, nearly impossible to control, and a consumer of resources that are devoted to it i...

Preparation and Characterization of Ni–TiO2 Nanocomposite Coatings Produced by Electrodeposition Technique

In this paper, Ni–TiO2 nanocomposite coatings with different sizes of TiO2 nanoparticles were successfully prepared by electrodeposition process from a nickel electrolyte in which the TiO2 nanoparticles were suspended. The influence of relevant deposition parameters on the nanocomposite coating characteristics was discussed. X-ray diffractometer has been applied in order to investigate the phas...

Investigations of Magnetic Properties Through Electrodeposition Current and Controlled Cu Content in Pulse Electrodeposited CoFeCu Nanowires

CoFeCu nanowires were deposited by pulsed electrodeposition technique into the porous alumina templates by a two-step mild anodization technique, using the single-bath method. The electrodeposition was performed in a constant electrolyte while Cu constant was controlled by electrodeposition current. The electrodeposition current was 3.5, 4.25, 5 and 6 mA. The effect of electrodeposition current...