Programming spindle speed variation in turning
نویسندگان
چکیده
منابع مشابه
Application of Spindle Speed Variation for Chatter Suppression in Turning
In the present paper the chatter instability of variable speed machining is studied. Though, there exist numerical methods for the computation of the stability lobes for variable speed machining, especially in turning processes the potential of an active spindle speed variation for chatter suppression is mostly unexploited. In the case of a slowly time-varying spindle speed, which is practicabl...
متن کاملPerturbation Analysis of Spindle Speed Variation in Machine Tool Chatter
Spindle speed variation has been shown to be an effective method for chatter control. In this paper, a single-degree-of-freedom regenerative type chatter equation is treated using perturbation methods. Rather than using the time coordinate, the angle of revolution is taken as the independent coordinate for maintaining a constant delay in the equations. The spindle speed is taken to be harmonica...
متن کاملMachine Tool Chatter Suppression Using Spindle Speed Variation
First part of the thesis deals with the dynamics and stability of nonlinear delay gyroscopic systems with periodically varying delay. The aim is to demonstrate that greater depths of cut may be achieved in a boring process (2 DOF) when the speed of the spindle is modulated sinusoidally instead of being kept constant. Since the variation of spindle speed is small and independent of the tool moti...
متن کاملMachinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملMachinability Investigation of Inconel 657 in High-speed Turning
A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Eastern-European Journal of Enterprise Technologies
سال: 2017
ISSN: 1729-4061,1729-3774
DOI: 10.15587/1729-4061.2017.95204