Precipitate formation in aluminium alloys: Multi-scale modelling approach
نویسندگان
چکیده
منابع مشابه
Anodic oxide formation on aluminium-terbium alloys
Aluminium terbium alloys were prepared by simultaneous thermal evaporation resulting in a thin film library covering a 5 to 25 at.% Tb compositional spread. Synchrotron x-ray diffraction (XRD) proves all of the alloys to be amorphous. Scanning electron microscopy (SEM) measurements reveal the structural changes upon increase in Tb content with the formation of small, Tb-rich segregations right ...
متن کاملThe Investigation of Modelling Material Behavior in Autofrettaged Tubes Made from Aluminium Alloys
Normal 0 false false false EN-US X-NONE AR-SA The ratio of compression yield strength to the initial tensile yield strength is called Bauschinger effect factor, BEF. A nonlinear strain hardening mathematical model is proposed for 7075 aluminium alloy (A7075). Uniaxial tension-compression experimental data are used to figure out a suitable model to study the BEF. Hence, uniaxial tension-co...
متن کاملModelling of Precipitation Hardening in Casting Aluminium Alloys
Precipitation hardening, because it involves the hardening of the material over a prolonged time, is also called age hardening, or ageing. By the appropriate heat treatment of precipitation hardening, the strength or hardness of some heat-treatable aluminium alloys can be enhanced by the formation of nano-meter sized second-phase precipitated particles within the original phase matrix. The fine...
متن کاملModelling of friction for high temperature extrusion of aluminium alloys
During high-temperature ball-on-disc tests of aluminium against steel, hot aluminium deformsand wear track evolves. The individual contributions of ploughing and shearing to theapparent friction and the contact pressure are unknown. The aim of this chapter was todevelop a model capable of determining these parameters. It was found that during high-temperature ball-on-disc tests,...
متن کاملNumerical Modelling of Drawbeads for Forming of Aluminium Alloys
The drawbeads in stamping tools are usually designed based on experience from the forming of steel. However, aluminium alloys display different forming behaviour to steels, which is not reflected in the drawbead design for tools used for stamping aluminium. This paper presents experimental results from different semi-circular drawbead geometries commonly encountered in automotive dies and compa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Acta Materialia
سال: 2020
ISSN: 1359-6454
DOI: 10.1016/j.actamat.2020.05.050