Plastic Deformation of Sendust Single Crystals
نویسندگان
چکیده
منابع مشابه
Plastic deformation of CoO single crystals
2014 Constant strain rate compressions along 001 > have been performed on CoO single crystals (03B5 ~ 6 x 10-5 s-1). Yield stresses and work hardening rates have been measured between 77 K and 1 400 K; CoO is very strong when compared to similar compounds. Vickers indentations have been performed on { 100 }, { 110 } and { 111 } faces around the Néel temperature, i.e. between 0 °C and 40 °C...
متن کاملPlastic deformation of single nanometer-sized crystals.
We report in situ electron microscopy observations of the plastic deformation of individual nanometer-sized Au, Pt, W, and Mo crystals. Specifically designed graphitic cages that contract under electron irradiation are used as nanoscopic deformation cells. The correlation with atomistic simulations shows that the observed slow plastic deformation is due to dislocation activity. Our results also...
متن کاملInfluence of Plastic Deformation on the Temperature Dependence of Ultrasonic Attenuation in Copper Single Crystals
The influence of plastic deformation (O<&<10%) on the MHz-ultrasonic attenuation a in single crystals of pure Cu, Cu50ppmAu and Cul30ppmAu has been measured over the temperature range 4<T<300K. The major contributions to the total attenuation originate from dislocation resonance, double-kink relaxation, phonon-electron interaction (at T<50K) and non-dislocation effects which are discussed espec...
متن کاملPseudoelastic Deformation of CuAlMn Single Crystals
Martensitic transformation associated with a tensile deformation of CuAlMn single crystals in [loo] direction was studied using in-situ transmission electron microscopy. Stress/strain curves obtained during pseudoelastic deformation of microscopic samples were slightly different fiom bulk ones due to martensite formation in the stage of stress increase and a permanent deformation during the fir...
متن کاملStress-strain relations for crystals containing plastic deformation.
Let P be one of the possible slip planes in a crystal, and let X be one of the possible slip directions in the plane P. Also let S be the magnitude of the shearing stress on the plane P resolved in the direction X, and So the critical value of S, i.e., the least value of S sufficient to permit slip or plastic deformation under the conditions specified in the following italicized statement; if s...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1981
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.45.12_1279