Phosphatability and Surface Characteristics of Silicon-Manganese Dual Phase Steel
نویسندگان
چکیده
منابع مشابه
Failure characteristics of a dual-phase steel sheet
Failure in ductile sheet metal structures is usually caused by one, or a combination of, ductile tensile fractures, ductile shear fractures or localised instability. In this paper the failure characteristics of the high strength steel Docol 600DP are explored. The study includes both experimental and numerical sections. In the experimental sections, the fracture surface of the sheet subjected t...
متن کاملImprovement of Mechanical Properties and Work-Hardening Behavior of Intercritically Annealed Dual Phase Steel
The effect of the initial microstructure and intercritical annealing on mechanical properties and work-hardening response of a high-formability low carbon steel were studied. The work-hardening analysis was based on the modified Crussard–Jaoul method. The ferritic-pearlitic sheets showed low strength and high total elongation with the appearance of the yield point phenomenon. The occurrence of ...
متن کاملEFFECT OF SILICON CONTENT ON THE STRAIN HARDENING OF DUAL-PHASE STEELS
Abstract: In the current work, the strain hardening behavior of dual-phase steels with different silicon content (0.34- 2.26 Wt. %) was examined using the modified Crussard-Jaoul analysis. It was shown that these dual-phase steels deform in two stages over a uniform strain range. Each stage exhibited a different strain hardening exponent varying with silicon content. At the first stage, work...
متن کاملExperimental Investigation and Optimizing Geometrical Characteristics and Surface Quality in Drilling of AISI H13 Steel
The aim of this paper is to investigate and optimize surface quality and geometrical characteristics in drilling process of AISI H13 steel, because they are critical items for precision manufacturing. After conducting the experiments, two regression models are developed to extensively evaluate the effect of drilling parameters on process outputs. After that, evolutionary multi-objective optimiz...
متن کاملGrain Refinement of Dual Phase Steel via Tempering of Cold-Rolled Martensite
A microstructure consisting of ultrafine grained (UFG) ferrite with average grain size of ~ 0.7 µm and dispersed nano-sized carbides was produced by cold-rolling and tempering of the martensite starting microstructure in a low carbon steel. Subsequently, fine grained dual phase (DP) steel consisting of equiaxed ferrite grains with average size of ~ 5 µm and martensite islands with average size ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1982
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.68.16_2497