Performance of Fuzzy Controlled Negative KY Boost Converter
نویسندگان
چکیده
منابع مشابه
The Feedback Pi Controller for Buck-boost Converter Combining Ky and Buck Converter
Most mobile equipments use battery as power source. The increasing use of low voltage portable devices and growing requirements of functionalities embedded into such devices. Thus an efficient power management technique is needed for longer battery life for them. Given the highly variable nature of batteries systems often require supply voltages to be both higher and lower than the battery. Thi...
متن کاملFuzzy Sliding Mode Controlled Single Phase AC/DC Boost PFC Converter
. Abstract: This paper presents a Fuzzy sliding mode controller (FSMC) used as a control technique for a Single phase AC/DC boost PFC converter for achieving high power factor and regulated voltage. The controller possesses the merits of both fuzzy controller and variable structure controller. The considered controller has advantages such as robustness when there is a large line and load variat...
متن کاملBasic Characteristics of Digitally Controlled Boost Type Dc-dc Converter
This paper presents the basic characteristics of the digitally controlled boost type dc-dc converter. The static and dynamic characteristics of the dc-dc converter with the digital PID control are discussed. Especially, it is examined that the A-D conversion timing and anti-aliasing filter’s cut-off frequency affect the dynamic and static characteristics. As a result, when the anti-aliasing fil...
متن کاملSimulation of Closed Loop Controlled Bridgeless Pfc Boost Converter
Conventional boost PFC converter suffers from the high conduction loss in the input rectifier-bridge. Higher efficiency can be achieved by using the bridgeless boost topology. In this paper, digital simulation of bridgeless PFC boost rectifiers, also called dual boost PFC rectifiers, is presented. Performance comparison between the conventional PFC boost rectifier and the bridgeless PFC boost r...
متن کاملA Fuzzy Logic Based Two Inductor Boost Converter System
Abstract: In many power factor correction applications, the power level can reach maximum value and sometimes the input voltage also will be too high. For high power and high voltage applications the inductor volume and weight is the major concern of the conventional boost converter. In this paper the two inductor boost converter is adopted which uses smaller inductors yielding high power densi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indian Journal of Science and Technology
سال: 2014
ISSN: 0974-6846,0974-5645
DOI: 10.17485/ijst/2014/v7i8.7