Performance evaluation of HVOF deposited cermet coatings under dry and slurry erosion
نویسندگان
چکیده
منابع مشابه
Effect of Porosity on Cavitation Erosion Resistance of HVOF Processed Tungsten Carbide Coatings
The phenomenon of cavitation is widely experienced in both pumps and under-water components of hydro power plants. The mechanism of material damage during cavitation is mainly attributed to implosion of high velocity bubbles on to the surface giving raise to local increase in stresses in excess of 1.4 GPa. In addition, material wastage due to particle induced erosion is observed in hydro plants...
متن کاملCharacterization of hydroxyapatiteynano-zirconia composite coatings deposited by high velocity oxy-fuel (HVOF) spray process
Hydroxyapatite (HA)ynano-zirconia composite coatings were successfully produced through high velocity oxy-fuel (HVOF) spraying of radio frequency (RF) plasma synthesized powders. Microstructure characterization and morphology analysis on the nano-structured coatings were conducted using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffractometry (XRD), and d...
متن کاملTribo-Mechanical Properties of HVOF Deposited Fe3Al Coatings Reinforced with TiB2 Particles for Wear-Resistant Applications
This study reveals the effect of TiB₂ particles on the mechanical and tribological properties of Fe₃Al-TiB₂ composite coatings against an alumina counterpart. The feedstock was produced by milling Fe₃Al and TiB₂ powders in a high energy ball mill. The high-velocity oxy-fuel (HVOF) technique was used to deposit the feedstock powder on a steel substrate. The effect of TiB₂ addition on mechanical ...
متن کاملCavitation Erosion of Cermet-Coated Aluminium Bronzes
The cavitation erosion resistance of CuAl10Ni5Fe2.5Mn1 following plasma spraying with Al₂O₃·30(Ni20Al) powder and laser re-melting was analyzed in view of possible improvements of the lifetime of components used in hydraulic environments. The cavitation erosion resistance was substantially improved compared with the one of the base material. The thickness of the re-melted layer was in the range...
متن کاملSLURRY EROSION RESISTANCE OF LASER CLAD Fe–Cr–B–Si COATINGS
The slurry erosion behaviour of laser clad Fe–Cr–B–Si alloy coatings was investigated at impact angles from 30u to 90u with an increment of 15u, and compared with the slurry erosion behaviour of two laser clad carbide coatings and a non-coated substrate made of AISI 4140 steel. The Fe–Cr–B–Si alloy coatings had slurry erosion resistance. Their overall slurry erosion resistance at impact angles ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Surface and Coatings Technology
سال: 2016
ISSN: 0257-8972
DOI: 10.1016/j.surfcoat.2016.05.039