Passive vibration damping of the APS machine components
نویسندگان
چکیده
منابع مشابه
Vibration Damping Analysis of Lightweight Structures in Machine Tools
The dynamic behaviour of a machine tool (MT) directly influences the machining performance. The adoption of lightweight structures may reduce the effects of undesired vibrations and increase the workpiece quality. This paper aims to present and compare a set of hybrid materials that may be excellent candidates to fabricate the MT moving parts. The selected materials have high dynamic characteri...
متن کاملperformance evaluation of viscoelastic and friction passive damping systems in vibration control of tall buildings
this paper provides a comparison of the maximum inter-story drifts and tip acceleration of both a 16 and 30 stories building each with different structural systems; hybrid r.c moment frame with shear walls and hybrid steel frame with shear walls and x bracing which are equipped by passive dampers. each of the building models were analyzed as fully non-linear structures for variety of dampers pl...
متن کاملVibration Characteristics of an Aps Lab Facility
The vibratory behavior of a lab facility located in Building 401 of the Advanced Photon Source site at Argonne National Laboratory is summarized. Measurements of ambient vibration indicate that acceptable displacement levels are usually maintained (rms value below 0.1 microns) for the measured frequency range, above 0.2 Hz. An exception occurs when strong wind conditions excite a horizontal bui...
متن کاملDamping Models for Structural Vibration
This dissertation reports a systematic study on analysis and identification of multiple parameter damped mechanical systems. The attention is focused on viscously and non-viscously damped multiple degree-offreedom linear vibrating systems. The non-viscous damping model is such that the damping forces depend on the past history of motion via convolution integrals over some kernel functions. The ...
متن کاملVibration Damping of High-Chromium Ferromagnetic Steel
The aim of the present work is to study the effect of annealing on the vibration damping capacity of high-chromium (16%) ferromagnetic steel. The alloys were prepared from raw materials of 99.9% purity melted in a high frequency induction furnace under high vacuum. The samples were heat-treated in vacuum at various temperatures (800 to 1200oC) for 1 hour followed by slow cooling (120oC/h). The ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Review of Scientific Instruments
سال: 1996
ISSN: 0034-6748,1089-7623
DOI: 10.1063/1.1147343