Oxide-Dispersion-Strengthened Nickel Produced by Non-Reactive Milling
نویسندگان
چکیده
منابع مشابه
Nanoscale lamellae in an oxide dispersion strengthened steel processed by dynamic plastic deformation
The microstructure of an oxide dispersion strengthened ferritic PM2000 steel with a strong initial 〈100〉 texture has been investigated after compression by dynamic plastic deformation (DPD) at room temperature to a strain of 2.1. Measurements using electron backscatter diffraction and transmission electron microscopy indicate that DPD along the 〈100〉 direction results in a lamellar-type microst...
متن کاملSynthesis, structural and magnetic characterization of nanocrystalline nickel ferrite-NiFe2O4 obtained by reactive milling
Nanocrystalline nickel ferrite (NiFe2O4) has been synthesized from a stoichiometric mixture of oxides NiO and α-Fe2O3 in a high energy planetary mill. A post milling annealing at 350 °C was used to improve the solid state reaction. The obtained powders were investigated by X-ray diffraction, magnetic measurements, scanning electron microscopy, X-ray microanalysis, differential scanning calorime...
متن کاملHydrogen evolution activity of NiMo-MoO2 produced by mechanical milling
In this study, mechanical alloying was done by a high-energy planetary ball milling technique. A mixture of NiO and MoO3 and graphite powders were used as initial materials. After milling of powder mixture with 40 wt.% additional graphite, a temperature of 400, 550 and 1000 °C for 1 h was considered for the heat treatment of powder mixture. Also, powder mixtures containing 60, 80 and 100 wt.% a...
متن کاملElectrochemical and Tribological Behaviour of Oxide Dispersion Strengthened Duplex Stainless Steel in Mine Water Environment
Abstract This work investigated the electrochemical and aqueous tribological behavior of hot pressed 2205 duplex stainless steel (DSS). DSS sintered composites of different volume percent (% vol) of partially stabilized zirconia (PSZ) was developed using powder metallurgy (PM) technique. Electrochemical behaviour was studied at room temperature, using open circuit potential and potentiody...
متن کاملEnhanced Densification of Cavitated Dispersion- Strengthened Aluminum by Thermal Cycling
We report experimental data of creep cavity shrinkage for dispersion-strengthened-cast aluminum with about 23 vol pct submicron Al2O3 dispersoids, annealed isothermally or subjected to thermal cycling without applied stress. Thermal cycling is found to increase the rate of densification by a factor of 3 to 5.5 relative to isothermal annealing at the upper cycling temperature, allowing for recov...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Powder Metallurgy
سال: 1976
ISSN: 0032-5899,1743-2901
DOI: 10.1179/pom.1976.19.3.153