Oxidative Coupling of Methane over Mn2O3-Na2WO4/SiC Catalysts
نویسندگان
چکیده
منابع مشابه
Oxidative coupling of methane over doped Li/MgO catalysts
A series of zirconia doped Li/MgO catalysts with a fixed amount of zirconia and varying concentrations of lithium was used for the oxidative coupling of methane. It was found that an increase in lithium concentration resulted in a decrease in initial activity, while the selectivity was not affected. The life-time of Zr doped Li/MgO catalysts with a fixed concentration of ZrOz is a function of t...
متن کاملMnTiO3-driven low-temperature oxidative coupling of methane over TiO2-doped Mn2O3-Na2WO4/SiO2 catalyst
Oxidative coupling of methane (OCM) is a promising method for the direct conversion of methane to ethene and ethane (C2 products). Among the catalysts reported previously, Mn2O3-Na2WO4/SiO2 showed the highest conversion and selectivity, but only at 800° to 900°C, which represents a substantial challenge for commercialization. We report a TiO2-doped Mn2O3-Na2WO4/SiO2 catalyst by using Ti-MWW zeo...
متن کاملEffect of Additives on Mn/SiO2 Based Catalysts on Oxidative Coupling of Methane
The Oxidative Coupling of Methane (OCM) over M-Na-Mn/SiO2 catalysts (M=W, Cr, Nb and V) was investigated using a continuous-flow quartz reactor at 775°C, 1 atm and 100 cm3min-1 gas flow rates, and correlated with the observed structure and redox properties.The interaction effects of the metal-metal and metal-support on the...
متن کاملModeling of Oxidative Coupling of Methane over Mn/Na2WO4/SiO2 Catalyst Using Artificial Neural Network
In this article, the effect of operating conditions, such as temperature, Gas Hourly Space Velocity (GHSV), CH4/O2 ratio and diluents gas (mol% N2) on ethylene production by Oxidative Coupling of Methane (OCM) in a fixed bed reactor at atmospheric pressure was studied over Mn/Na2WO4/SiO2 ca...
متن کاملPotassium/calcium/nickel oxide catalysts for oxidative coupling of methane
A series of potassium/calcium/nickel oxides were tested for the oxidative coupling of methane (OCM) at 843-943 K and water addition to the feed at O-65 mol-%. The K/Ni ratios varied from 0.0-0.6 and Ca/Ni from 0.0-11; catalysts with no nickel were also tested. At least 10% water in the feed and temperatures lower than ca. 940 K were necessary to keep nickel-containing catalysts from converting ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Catalysts
سال: 2019
ISSN: 2073-4344
DOI: 10.3390/catal9040363