Optimization of ZnO/Ag/ZnO Transparent Conductive Electrodes Fabricated by Magnetron Sputtering

Transparent, conductive ZnO:Al thin film deposited on polymer substrates by RF magnetron sputtering

In this paper, we present the optical, electrical, structural and mechanical properties exhibited by aluminum-doped zinc oxide (ZnO:Al) thin films produced by RF magnetron sputtering on polymeric substrates (polyethylene terephthalate, PET; Mylar type D from Dupont ) with a standard thickness of 100 mm. The influence of the uniaxial tensile strain on the electrical resistance of these films was...

Cu Mesh for Flexible Transparent Conductive Electrodes

Copper electrodes with a micromesh/nanomesh structure were fabricated on a polyimide substrate using UV lithography and wet etching to produce flexible transparent conducting electrodes (TCEs). Well-defined mesh electrodes were realized through the use of high-quality Cu thin films. The films were fabricated using radio-frequency (RF) sputtering with a single-crystal Cu target--a simple but inn...

Copper Nanowires as Fully Transparent Conductive Electrodes

In pondering of new promising transparent conductors to replace the cost rising tin-doped indium oxide (ITO), metal nanowires have been widely concerned. Herein, we demonstrate an approach for successful synthesis of long and fine Cu nanowires (NWs) through a novel catalytic scheme involving nickel ions. Such Cu NWs in high aspect ratio (diameter of 16.2 ± 2 nm and length up to 40 μm) provide l...

Highly conductive ultrathin Co films by high-power impulse magnetron sputtering

Fabrication of transparent conducting amorphous Zn–Sn–In–O thin films by direct current magnetron sputtering

Amorphous ZnO–SnO2–In2O3 films were grown by direct current magnetron sputtering from vacuum hot pressed ceramic oxide targets of Zn: In:Sn cation ratios 1:2:1 and 1:2:1.5 onto glass substrates. X-ray diffraction analysis showed that the microstructure remained amorphous during annealing at 200 °C for up to 5 hours. By monitoring the electrical resistivity, oxygen content and substrate temperat...