On some other preferred method for optimizing the welded joint
نویسندگان
چکیده
منابع مشابه
Optimizing the Process Parameters of Friction Stir Welded Joint of Magnesium Alloy Az31b
This paper deals with Friction stir welding of AZ31B Mg alloy by using H13 Tool at different rotational speeds and welding speeds .Experiments were conducted according to L4 Orthogonal array which was suggested by Taguchi. Optimum parameters for optimum Tensile strength, Hardness and Ductility were found with the help of S/N ratios. Therefore optimization of input process parameter is required ...
متن کاملThe Inherent Strain Method for Residual Stress Determination and Its Application to a Long Welded Joint
In this paper, we investigate a relatively new method for determining three-dimensional sub-surface residual stress (Ueda, 1975). This hybrid experimental/analytical method determines the source of residual stress by sectioning and strain measurement, and then uses it to deduce residual stress in the original body. When certain assumptions about the spatial distribution of the source of residua...
متن کاملPreferred Strategies for Optimizing Convolution on VLIW DSP Architectures
1. Abstract Convolution is a central algorithm for implementing linear time invariant systems that constitute the heart of most digital signal processing algorithms. Performance on the linear convolution algorithm has been one of the primary benchmarks used to discern the performance of dedicated digital signal processing architectures (DSP). While DSP benchmarks are far more varied and complex...
متن کاملglobal results on some nonlinear partial differential equations for direct and inverse problems
در این رساله به بررسی رفتار جواب های رده ای از معادلات دیفرانسیل با مشتقات جزیی در دامنه های کراندار می پردازیم . این معادلات به فرم نیم-خطی و غیر خطی برای مسایل مستقیم و معکوس مورد مطالعه قرار می گیرند . به ویژه، تاثیر شرایط مختلف فیزیکی را در مساله، نظیر وجود موانع و منابع، پراکندگی و چسبندگی در معادلات موج و گرما بررسی می کنیم و به دنبال شرایطی می گردیم که متضمن وجود سراسری یا عدم وجود سراسر...
Tensile Properties of Ferrite-austenitic Welded Joint
Very often, in order to optimized welded constructions, some of their parts are made of heterogeneous steels. For example, microalloyed steels are in use for cars chassis making and high alloyed steels for different constructions making. From that reason, it’s not rare to find welded joints between ferrite microalloyed and austenitic highalloyed steels. As a rule, these joints are welded by usi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tehnika
سال: 2016
ISSN: 0040-2176
DOI: 10.5937/tehnika1606838p