منابع مشابه
The Effects of ZrO2 or Tic on the Performance of the Alumina-Based Ceramic Cutting Tools
Two types of alumina-based cutting tools with compositions of 90 vol.% Al2O3+10 vol.% ZrO2 and 80 vol.% A12O3+20 vol.% TiC are produced by isostatic pressing and sintering technique. The effects of these additives on the mechanical properties and cutting performance of these materials are investigated. The tool life in both materials is examined under identical conditions on cutting a grey cast...
متن کاملResearch on Cutting Performance of Ceramic Cutting Tools in Milling High Density Fiberboard
The effect of cutting parameters and tool parameters on cutting forces and tool wear were investigated in high density fiberboard (HDF) peripheral up-milling using toughened ceramic cutting tools. The results showed that whether at low speed cutting or high speed cutting, the tangential forces Ft and normal forces Fr increased slowly with the increase of cutting length. The tangential forces Ft...
متن کاملComparison of Cutting Ceramics with Hard Metal Cutting Tools
Cutting ceramic tools are used especially at high cutting speeds in the machining process. The highly brittle type of structure and the tendency for cleavage (crack formation) are the infavorable properties of these materials, which keep their hardness at high temperatures. The hard metals are produced by sintering of the carbides such as whisker WC, TiC and TaC with the presence of Co as a bin...
متن کاملCVD diamond coatings on geometrically complex cutting tools
The manufacturing of chemical vapour deposition (CVD) diamond coated shaft type cutting tools is demanding due to the complex design of the cutting edges and the cobalt content of the cemented carbide. The influencing parameters of substrate, pre-treatment and diamond film on the tool cutting performance are discussed. The optimised manufacturing route of CVD diamond coated thread milling drill...
متن کاملOn Stress Analysis of Diamond Coating Cutting Tools
Diamond coatings have been increasingly used in cutting tools applications. Coating delamination is the major tool failure mode and occurs due to deposition-induced residual stresses and thermomechanical loading in machining. This study applies finite element analysis to investigate stress distributions, with the edge radius focused, in diamond coating tools considering depositions and machinin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1957
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.23.691