Numerical process simulation of hot forming
نویسندگان
چکیده
منابع مشابه
Investigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملCoupled numerical simulation of hot stamping process and experimental verification
Hot stamping process is a high non-linear process showing the effect on thermal, mechanical and metallurgical phenomena as they relate to each other. In order to carry out this coupled numerical simulation, fundamental thermal properties such as interfacial heat transfer coefficient and convection heat transfer coefficient as well as crucial mechanics properties were first investigated. Hot sta...
متن کاملNumerical study on the effect of input variations on bulge height in hot tube metal gas forming process
.Hot metal gas forming of tubes can be used in various industries such as automotive and aerospace industries. In this process tube is formed at elevated temperatures, by using gas instead of fluid pressure. Lower required pressure and low power are its advantages in comparison to hydroforming process. In this paper, a hot metal gas bulging process of an aluminum alloy tube has been investigate...
متن کاملNumerical study on the effect of hammering pressure on thickness reduction in hot tube metal gas forming process
Nowadays, light weight and high strength metals are being used in various industries such as automotive and aerospace. Using aluminum-magnesium alloys is an efficient way to reduce the weight of a specific part. These alloys have poor formability in room temperature thus they should be formed at elevated temperature. Warm hydroforming and hot metal gas forming are conventional methods to form ...
متن کاملSimulation of Orbital Forming Process
In this study the feasibility of 3D FEM simulation of the orbital forming process was investigated by evaluating the simulation time. Commercial FEA software DEFORM 3D v4.0 that has an efficient computation algorithm for simulating incremental forming process was used for the simulations and the savings in computation time was determined. In order to provide reliable flow stress for the simulat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Light Metals
سال: 2021
ISSN: ['0451-5994', '1880-8018']
DOI: https://doi.org/10.2464/jilm.71.152