منابع مشابه
Numerical modelling of the growth of offshore sand waves
i Numerical modelling of the growth of offshore sand waves Preface This thesis is my final work carried out for the double degree Master of Science programme in Hydraulic Engineering and Water Resources Management at the Delft University of Technology and the National University of Singapore. The study was carried out at Deltares and covers various modelling aspects of the growth of offshore sa...
متن کاملNumerical Modelling of the Czochralski Growth of -Ga2O3
Our numerical modelling of the Czochralski growth of single crystalline β-Ga2O3 crystals (monoclinic symmetry) starts at the 2D heat transport analysis within the crystal growth furnace, proceeds with the 3D heat transport and fluid flow analysis in the crystal-melt-crucible arrangement and targets the 3D thermal stress analysis within the β-Ga2O3 crystal. In order to perform the stress analysi...
متن کاملNumerical Modelling of the Segmental Lining of Underground Structures
There are several methods for analysing the behaviour of underground structures under different loading conditions. Most of these methods have many simplifications; therefore, in some cases, the results are too conservative and a very high safety factor, usually of more than 2 is needed. On the other hand, for stability analysis and the designing of support systems, these methods consider segme...
متن کاملNumerical modelling of induced rip currents by discontinuous submerged breakwaters
Submerged breakwaters are one of the shore protective structures. Any discontinuity in these breakwaters causes changes on current parameters including speed and water surface profile. In this paper, discontinuous submerged breakwaters were modelled to investigate the changes in the wave and flow pattern.To investigate the phenomenon, three models including a shore with constant slope, a shore ...
متن کاملNumerical Modelling of Backfill Grouting Approaches in EPB Tunneling
One of the main issues involved during tunnel construction with tunnel boring machines is the tail gap grouting. This gap is between the external diameter of tunnel lining and the excavation boundary that is filled with high-pressure grouting materials. In this work, three different approaches of gap grouting modeling in the FLAC3D software are investigated with a special attention to the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Japanese Geotechnical Society Special Publication
سال: 2016
ISSN: 2188-8027
DOI: 10.3208/jgssp.atc1-3-17