Numerical investigation of condensing flow of low pressure steam turbine at different flow rate conditions
نویسندگان
چکیده
منابع مشابه
Numerical Modeling of Wet Steam Flow in Steam Turbine Channel
In power station practice, work is extracted from expanding steam in three stages namely High Pressure(HP), Intermediate Pressure(IP) and Low Pressure(LP) turbines. During the expansion process in the LP turbine, the steam cools down and at some stages, it nucleates to become a two-phase mixture. It is well-acknowledged in the literature that the nucleating and wet stages in steam turbines are ...
متن کاملNumerical Simulation of Flow Fields in Diaphragm Gland of Steam Turbine
The leakage characteristics of the bending-teeth gland, which may be helpful for the fast start and fast stop of the steam turbine, was discussed in this paper by using ANSYS6.1 software. By compared the flow fields in straight-teeth gland and bending-teeth gland, the methods for the bending-teeth gland to decrease the steam leakage was proposed. The results show that, although the leakage of t...
متن کاملNumerical Investigation of Flow Field of D87 Dual Fuel Engine
A newly developed heavy duty diesel engine in dual fuel mode of operation has been studied in detail. The main fuel would be natural gas and diesel oil as pilot injection. The importance and effects of mixture preparation and formation through ports, valves and in cylinder flow field with different swirl ratio and tumble on diesel combustion phenomena is an accepted feature which has been studi...
متن کاملElimination of Flow-induced Instability from Steam Turbine Control Valves
This paper describes two steam turbine governor valve failures in the same installation, the troubleshooting that determined the root cause, and the new valve designed to prevent similar failures. The original governor valve design had been used successfully for many years in large multistage, multivalve steam turbines, but apparently was not reliable at the high steam pressures employed today....
متن کاملNumerical Investigation of Shock Tube Flow under Rarefied Conditions
Two-dimensional Direct Simulation Monte Carlo (DSMC) simulations are carried out for investigating the shock wave propagation and boundary layer effects in a shock tube flow, for a wide range of rarefied conditions. Nitrogen is used for all simulations. The Cercignani-Lampis-Lord (CLL) model of gas surface interactions is implemented to study the effects of boundary layer which develops behind ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Thermal Science
سال: 2017
ISSN: 0354-9836,2334-7163
DOI: 10.2298/tsci17s1161h