Novel elastic deformation mechanism in multifunctional Ti–Nb alloy
نویسندگان
چکیده
منابع مشابه
Pseudo-elastic deformation behavior in a Ti/Mo-based alloy
It is shown that the pseudo-elastic response in a series of Ti–Mo–V–Nb–Al alloys with 8–11 wt.% Mo is highly sensitive to both composition and heat treatment. Recovery of up to 3.0% strain has been observed but it appears that this may not be due to reversible formation of a00 martensite. 2003 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
متن کاملMultifunctional Alloys Obtained via a Dislocation-Free Plastic Deformation Mechanism.
We describe a group of alloys that exhibit "super" properties, such as ultralow elastic modulus, ultrahigh strength, super elasticity, and super plasticity, at room temperature and that show Elinvar and Invar behavior. These "super" properties are attributable to a dislocation-free plastic deformation mechanism. In cold-worked alloys, this mechanism forms elastic strain fields of hierarchical s...
متن کاملPLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملFormation mechanism of fivefold deformation twins in a face-centered cubic alloy
The formation mechanism considers fivefold deformation twins originating from the grain boundaries in a nanocrystalline material, resulting in that fivefold deformation twins derived from a single crystal have not been reported by molecular dynamics simulations. In this study, fivefold deformation twins are observed in a single crystal of face-centered cubic (fcc) alloy. A new formation mechani...
متن کاملElastic deformation of twinned microstructures
Many crystalline materials exhibit twinned microstructures, where well-defined orientation relationships define the special symmetry between different, elastically anisotropic twin variants. When such twins are subjected to external loading, additional internal stresses necessarily occur at the twin boundaries in order to maintain compatibility. These compatibility stresses are constant inside ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Letters
سال: 2017
ISSN: 0167-577X
DOI: 10.1016/j.matlet.2016.10.042